Samsung 900IFT manual Adjust the trapezoid setting, Rotation setting, Pincushion/Trapezoid

Page 10

SE-900IFT-E 4/29/92 5:23 PM Page 8

Chapter Three: Adjusting Your Monitor

		Pincushion/Trapezoid
Pincushion/Trapezoid		Adjust the pincushion setting when the sides of the display
▲	54	are bowed in or bowed out; adjust the trapezoid setting
		when the top or bottom of the display is too large or too
▲	▲
▼	62	small.
		1	With the menu off, push the	button.

			The pincushion/trapezoid screen will appear.
		2	Use the $ button or % button to adjust the
			pincushion setting; use the ▲ button or ▼ button to
			adjust the trapezoid setting.
		Parallel/Rotation
Parallel/Rotation		Adjust the parallelogram setting when the display is leaning

▲54 left or right; adjust the rotation setting when the entire

▲		▲	display is tilted left or right.
	▼		62
	▼		1	With the menu off, push the	button twice.
				With the menu off, push the	button twice.
				The parallelogram/rotation screen will appear.
			2	Use the $ button or % button to adjust the parallel
			2	setting; use the ▲ button or ▼ button to adjust the

rotation setting.

Image 10

Contents SyncMaster 900IFT Unpacking your Monitor Table of Contents Preface Safety Information Chapter One Overview of Your Monitor Power indicatorPower button ButtonSignal port Power portConnect the power cord here Connect your signal cable hereConnecting Your Monitor Chapter Two InstallationTo a Computer Menu Chapter Three Adjusting Your MonitorOverview Previous menu levelChange the horizontal size of the monitor’s display Direct-Access FeaturesButton twice PositionPincushion/Trapezoid Adjust the trapezoid settingRotation setting Parallel/RotationMenu Features Screen Push the $ button to select YES Degaussing screen will appearReturn Button to select noPosition you prefer Push Button to open the menu position Adjustment screenSeconds seconds is the default value Screen Use the $ button or % button to select BNC or SUBUntil the moiré effect is cleared SettingYou would like to use Factory timings You cannot select a new settingIs displayed Level screen is displayedSync. On Green $ button or % button until the Sync. Input TypePush Button to open the sync input type Selection screen Push the Menu buttonPowerSaver Adjust the Size settings TroubleshootingAdjust the Brightness or Contrast settings Activate the Degauss featureSpecifications AppendixSUB Connectors Pin AssignmentsSignals Display Modes Timing ChartBNC Connectors Display Mode Horizontal Vertical Pixel Sync PolarityIndex IC Compliance Notice Regulatory InformationFCC Information MPR II ComplianceCode NO. BH68-00031A Rev SyncMaster 900IFT Owner’s Instructions

Chapter Three: Adjusting Your Monitor

Pincushion/Trapezoid

adjust the trapezoid setting.

Parallel/Rotation

button twice.

rotation setting.