Samsung 900IFT manual Appendix, Specifications

Page 19

SE-900IFT-E 4/29/92 5:23 PM Page 17

 

 

 

Appendix

Specifications

 

 

 

Picture Tube

• 19" (48 cm) Full square type [18" (45.8 cm) Viewable]

 

• Flat face, 90˚ Deflection

 

• Dot pitch: 0.20 (Horizontal)/0.24 (Diagonal)

 

Anti-reflection coating with anti-electrostatic properties

 

Medium-short persistence phosphor

Synchronization

• Horizontal: 30 kHz to 96 kHz (Automatic)

 

• Vertical:

50 Hz to 160 Hz (Automatic)

Display Color

• Unlimited colors

 

Maximum Resolution

• Horizontal: 1600 Dots

 

• Vertical:

1200 Lines

Active Display

• Horizontal: 13.85" ± 0.12" (352 ± 3 mm) (4:3)

 

 

12.99" ± 0.12" (330 ± 3 mm) (5:4)

 

• Vertical:

10.39" ± 0.12" (264 ± 3 mm)

 

 

(Active display size is dependent upon signal timing)

Input Signal,Terminated

• Video signal:

Analog 0.7 Vpp positive at 75 Ω

 

• Separate sync: TTL Level, positive or negative

 

• Composite sync: TTL Level, positive or negative

 

Sync-on-Green: Composite sync 0.3 Vpp negative

 

 

 

(Video 0.7 Vpp positive)

Maximum Pixel Clock

• 205 MHz

 

 

Power Supply

• AC 100-240 Volt ± 10%, 60 Hz/50 Hz ± 3 Hz

Power Consumption

• 130 Watt maximum

Dimensions/Weight

• Unit: 18.4 x 19.4 x 19.0 in; 53.8 lbs (468.0 x 492.0 x 483.2 mm; 24.4 kg)

(W x D x H)

• Carton: 22.6 x 25.8 x 22.8 in; 62.8 lbs (573.0 x 656.0 x 580.0 mm; 28.5 kg)

 

(All measurements are approximate.)

Environmental Considerations

Operating Temperature: 32˚F to 104˚F (0˚C to 40˚C) Humidity: 10% to 80%

Storage Temperature: -4˚F to 113˚F (-20˚C to 45˚C) Humidity: 5% to 95%

English EnglishFrançais Español Deutsch Português Italiano

17

Image 19
Contents SyncMaster 900IFT Unpacking your Monitor Table of Contents Preface Safety Information Button Power indicatorPower button Chapter One Overview of Your MonitorConnect your signal cable here Power portConnect the power cord here Signal portConnecting Your Monitor Chapter Two InstallationTo a Computer Previous menu level Chapter Three Adjusting Your MonitorOverview MenuPosition Direct-Access FeaturesButton twice Change the horizontal size of the monitor’s displayParallel/Rotation Adjust the trapezoid settingRotation setting Pincushion/TrapezoidMenu Features Button to select no Degaussing screen will appearReturn Screen Push the $ button to select YESScreen Use the $ button or % button to select BNC or SUB Push Button to open the menu position Adjustment screenSeconds seconds is the default value Position you preferUntil the moiré effect is cleared SettingYou would like to use Level screen is displayed You cannot select a new settingIs displayed Factory timingsPush the Menu button $ button or % button until the Sync. Input TypePush Button to open the sync input type Selection screen Sync. On GreenPowerSaver Activate the Degauss feature TroubleshootingAdjust the Brightness or Contrast settings Adjust the Size settingsAppendix SpecificationsPin Assignments SUB ConnectorsDisplay Mode Horizontal Vertical Pixel Sync Polarity Display Modes Timing ChartBNC Connectors SignalsIndex MPR II Compliance Regulatory InformationFCC Information IC Compliance NoticeCode NO. BH68-00031A Rev SyncMaster 900IFT Owner’s Instructions