Samsung 900IFT manual Direct-Access Features, Button twice, Position, Size

Page 9

SE-900IFT-E 4/29/92 5:23 PM Page 7

Chapter Three: Adjusting Your Monitor

Direct-Access Features

The features described on this page and the next page can be accessed quickly, at the touch of one button. Once you have adjusted one of these features, push the button once or twice to turn off the display.

English

	Position
	▲
▲	▲

Position

Follow these instructions to change the position of the

54monitor’s entire display.

FrançaisEnglish

▼

621

2

With the menu off, push the button. The position display will appear.

Use the ▲ and ▼ buttons to change the vertical position of the monitor’s entire display; use the $ and % buttons to change the horizontal position of the monitor’s entire display.

Español

Size

5 4

6 6

Size

Follow these instructions to change the size of the monitor’s entire display.

1	With the menu off, push the				button twice.

	The size display will appear.
2	Push the ▲ or ▼ buttons to change the vertical size
	of the monitor’s display; push the $ or % buttons to

change the horizontal size of the monitor’s display.

Deutsch Português Italiano

7

Image 9

Contents SyncMaster 900IFT Unpacking your Monitor Table of Contents Preface Safety Information Power button Power indicatorChapter One Overview of Your Monitor ButtonConnect the power cord here Power portSignal port Connect your signal cable hereChapter Two Installation Connecting Your MonitorTo a Computer Overview Chapter Three Adjusting Your MonitorMenu Previous menu levelButton twice Direct-Access FeaturesChange the horizontal size of the monitor’s display PositionRotation setting Adjust the trapezoid settingPincushion/Trapezoid Parallel/RotationMenu Features Return Degaussing screen will appearScreen Push the $ button to select YES Button to select noSeconds seconds is the default value Push Button to open the menu position Adjustment screenPosition you prefer Screen Use the $ button or % button to select BNC or SUBSetting Until the moiré effect is clearedYou would like to use Is displayed You cannot select a new settingFactory timings Level screen is displayedPush Button to open the sync input type Selection screen $ button or % button until the Sync. Input TypeSync. On Green Push the Menu buttonPowerSaver Adjust the Brightness or Contrast settings TroubleshootingAdjust the Size settings Activate the Degauss featureAppendix SpecificationsPin Assignments SUB ConnectorsBNC Connectors Display Modes Timing ChartSignals Display Mode Horizontal Vertical Pixel Sync PolarityIndex FCC Information Regulatory InformationIC Compliance Notice MPR II ComplianceCode NO. BH68-00031A Rev SyncMaster 900IFT Owner’s Instructions