Samsung 900IFT manual You cannot select a new setting, Is displayed, Factory timings

Page 15

SE-900IFT-E 4/29/92 5:23 PM Page 13

▲

▲

▲

Hz ▲ G

Factory Timing

31k/ 70 720x 400 31k/ 60 640x 480 ▲ 43k/ 85 640x 480 54k/ 85 800x 600 ▼ 68k/ 85 1024x 768

Previous Menu

▲

▲

Hz	▲	G
	▲

Video Input Level

▲ 0.7V

1.0V

▼

Previous Menu

Chapter Three: Adjusting Your Monitor

Display Timing

This screen displays the settings that are available to your monitor. This screen only displays this information;

you cannot select a new setting.


1	With the menu off, push the MENU button. Push the $
	button or % button until the “Display Timing” screen
	is displayed.
2 Push the				button to display the factory timing screen.

3	Use the ▲ button or ▼ button to display the user and
	factory timings.

Video Input Level

This feature will select the video signal level.

1	With the menu off, push the MENU button.
	Push the $ button or % button until the “Video Input
	Level” screen is displayed.
2	Push the			button to open the video input level

	selection screen.

3 Use the $ or % buttons to select 0.7 V or 1.0 V.

NOTE: Some video cards use video signals higher than 1.0 V which causes the display to be very bright.

For those video cards, select 1.0 V.

.

English EnglishFrançais Español Deutsch Português Italiano

13

Image 15

Contents SyncMaster 900IFT Unpacking your Monitor Table of Contents Preface Safety Information Button Power indicatorPower button Chapter One Overview of Your MonitorConnect your signal cable here Power portConnect the power cord here Signal portChapter Two Installation Connecting Your MonitorTo a Computer Previous menu level Chapter Three Adjusting Your MonitorOverview MenuPosition Direct-Access FeaturesButton twice Change the horizontal size of the monitor’s displayParallel/Rotation Adjust the trapezoid settingRotation setting Pincushion/TrapezoidMenu Features Button to select no Degaussing screen will appearReturn Screen Push the $ button to select YESScreen Use the $ button or % button to select BNC or SUB Push Button to open the menu position Adjustment screenSeconds seconds is the default value Position you preferSetting Until the moiré effect is clearedYou would like to use Level screen is displayed You cannot select a new settingIs displayed Factory timingsPush the Menu button $ button or % button until the Sync. Input TypePush Button to open the sync input type Selection screen Sync. On GreenPowerSaver Activate the Degauss feature TroubleshootingAdjust the Brightness or Contrast settings Adjust the Size settingsAppendix SpecificationsPin Assignments SUB ConnectorsDisplay Mode Horizontal Vertical Pixel Sync Polarity Display Modes Timing ChartBNC Connectors SignalsIndex MPR II Compliance Regulatory InformationFCC Information IC Compliance NoticeCode NO. BH68-00031A Rev SyncMaster 900IFT Owner’s Instructions