Samsung 900IFT manual Power port, Connect the power cord here, Signal port, BNC signal port

Page 6

SE-900IFT-E 4/29/92 5:23 PM Page 4

Chapter One: Overview of Your Monitor

H/V

Rear Panel

Power port

Connect the power cord here.

Signal port

Connect your signal cable here.

BNC signal port

Connect a BNC signal cable here. (BNC signal cable not included.)

Image 6

Contents SyncMaster 900IFT Unpacking your Monitor Table of Contents Preface Safety Information Chapter One Overview of Your Monitor Power indicatorPower button ButtonSignal port Power portConnect the power cord here Connect your signal cable hereChapter Two Installation Connecting Your MonitorTo a Computer Menu Chapter Three Adjusting Your MonitorOverview Previous menu levelChange the horizontal size of the monitor’s display Direct-Access FeaturesButton twice PositionPincushion/Trapezoid Adjust the trapezoid settingRotation setting Parallel/RotationMenu Features Screen Push the $ button to select YES Degaussing screen will appearReturn Button to select noPosition you prefer Push Button to open the menu position Adjustment screenSeconds seconds is the default value Screen Use the $ button or % button to select BNC or SUBSetting Until the moiré effect is clearedYou would like to use Factory timings You cannot select a new settingIs displayed Level screen is displayedSync. On Green $ button or % button until the Sync. Input TypePush Button to open the sync input type Selection screen Push the Menu buttonPowerSaver Adjust the Size settings TroubleshootingAdjust the Brightness or Contrast settings Activate the Degauss featureSpecifications AppendixSUB Connectors Pin AssignmentsSignals Display Modes Timing ChartBNC Connectors Display Mode Horizontal Vertical Pixel Sync PolarityIndex IC Compliance Notice Regulatory InformationFCC Information MPR II ComplianceCode NO. BH68-00031A Rev SyncMaster 900IFT Owner’s Instructions