Samsung 900IFT manual Push Button to open the menu position Adjustment screen, Position you prefer

SE-900IFT-E 4/29/92 5:23 PM Page 11

▲

▲

▲

Hz ▲ G

Menu Position

	▲
▲	▼
	▼

Previous Menu

▲

▲

		Hz	▲	G
			▲
	Menu Duration
▲3	7	10	20	50▼
		(Seconds)

Previous Menu

Chapter Three: Adjusting Your Monitor

Menu Position

You can change the position where the menu appears on your monitor.

1	With the menu off, push the MENU button. Push the
	$button or %button until the “Menu Position” screen
	is displayed.
2	Push the	button to open the menu position
	adjustment screen.
3	Use the ▲, ▼, $ or % buttons to place the menu in
	the position you prefer.

Menu Duration

The menu will automatically turn off if no adjustments are made for a certain time period. You can set the amount of time the menu will wait before it turns off.

1	With the menu off, push the MENU button.
	Push the $ button or % button until the “Menu
	Duration” screen is displayed.
2	Push the	button to open the menu duration
	selection screen.
3	Use the $ or % buttons to select 3, 7, 10, 20, or 50
	seconds. 10 seconds is the default value.

D-SUB/BNC

Use this menu to choose between the signal source connected to the BNC connector input and the signal source connected to the D-SUB connector input.

1	With the menu off, push the MENU button.
	Push the $button or %button until the “D-SUB/BNC”
2	screen is displayed.
	Push the	button to open the D-SUB/BNC selection
	screen.
3	Use the $ button or % button to select “BNC” or
	“D-SUB”.

NOTE: When you are finished, wait for a few seconds and the screen will blank then display the image from the new signal source (Other computer). A cable must be connected to both inputs to use this function.

English EnglishFrançais Español Deutsch Português Italiano

11