JVC CA-MXJ75R manual Reinforcing the Bass Sound, On the remote control only, Press and hold Shift

Page 16
SOUND MODE
SOUND MODE

English

To turn down the volume level temporarily FADE

MUTING

Press FADE MUTING on the remote control.

The volume level gradually decreases to “0.”

To restore the sound, press the button again.

Adjusting the Front Speaker Output Balance

Selecting the Sound Modes

You can select one of the 6 preset sound modes (3 surround modes and 3 SEA — Sound Effect Amplifier — modes). The sound modes can be applied only to playback sounds, and cannot be used for recording.

To select the sound modes, press SOUND MODE SOUND

If the sounds you hear from the front right and left speakers

are unequal, you can adjust the speaker output balance.

On the remote control ONLY:

SHIFT

1 Press and hold SHIFT.

 

until the sound mode you want appears on the display. The SOUND MODE indicator also lights up on the display.

MODE

2 Press BALANCE L/R button.

L BALANCE R

Pressing BALANCE L decreases the right channel output.

Pressing BALANCE R decreases the left channel output.

3 Release SHIFT.

Reinforcing the Bass Sound

The Signal Adaptive Bass function provided for this unit can enhance the bass sound while listening to any source at low volume.

You can use this function only for playback.

To turn on the function, press S.A.BASS

S. A. BASS

repeatedly until “SA-BASS1” or “SA-BASS2”

 

appears on the display.

 

The S.A.BASS lamp (the button itself) also lights up.

• Each time you press the button, the Signal Adaptive Bass level applied to the playback sound changes as follows:

SA-BASS1 SA-BASS2

OFF

(Canceled)

When you select “SA-BASS2,” the bass sound level is enhanced much more than when you select “SA-BASS1.”

While playing back some sources, the level difference between “SA-BASS1” and “SA-BASS2” may not be distinct.

To turn off the function, press the button repeatedly until “OFF” appears on the display.

If you want to check the Signal Adaptive Bass level currently selected

While the S.A.BASS lamp is lit, press S.A.BASS once so that the current level appears for a while.

Each time you press the button, the sound modes change as follows:

D.CLUB HALL STADIUM ROCK

(Dance CLUB)

POP

OFF

 

 

 

 

 

 

 

 

(Canceled)

 

CLASSIC

 

 

 

 

 

 

 

 

MANUAL3

 

 

 

 

 

 

 

 

MANUAL2

 

MANUAL1

 

 

 

 

 

 

 

 

Surround modes *:

D.CLUB: Increases resonance and bass.

HALL: Adds depth and brilliance to the sound.

STADIUM: Adds clarity and spreads the sound, like in an outdoor stadium.

SEA modes:

ROCK: Boosts low and high frequency. Good for acoustic music.

POP:Good for vocal music.

CLASSIC: Good for classical music.

Manual modes:

MANUAL1/2/3: Your individual mode stored in memory. See “Creating Your Own Sound Mode — Manual Mode.”

OFF:Cancels the sound mode.

* Surround elements are added to the SEA elements to create a being-there feeling in your room.

When one of these modes is selected, the SOUND MODE indicator lights up as —

While one of the SEA modes including manual modes (SEA elements without surround elements) is selected,

it lights up as —

– 11 –

Image 16
Contents CA-MXJ75R Power can be remote controlled Page CA-MXJ75R Class Laser Product Introduction PrecautionsAbout This Manual Contents Location of the Buttons and Controls Powered Rolling PanelBecome familiar with the buttons and controls on your unit Front Panel Display WindowSee pages in the parentheses for details Disc number buttons and lamps CD 1, CD 2, and CD 3Remote Control Remote ControlAUX button FM/AM buttonConnecting Antennas Getting StartedUnpacking FM antennaConnecting Speakers Release the finger from the clampAM MW/LW antenna To connect front speakersConnecting Other Equipment To connect a center speaker and rear speakersTo connect an analog component To connect a subwooferPress and hold Demo for more than 2 seconds To start the display demonstration manuallyTo stop the display demonstration, press any button on To stop the demonstration, press any buttonSetting the Clock Turning On the Power and Selecting the SourcesAdjusting the Volume Common OperationsOn the remote control only Reinforcing the Bass SoundPress and hold Shift Press Balance L/R buttonCreating Your Own Sound Mode Manual Mode Tuning in a Preset Station Tuning in a StationPresetting Stations Searching for Programs by PTY Codes PTY Search Receiving FM Stations with RDSChanging the RDS Information Switching to a Program Type of Your Choice Temporarily Press PTY/EON until EONSelect alternately appear on the display Press Select / + until the EONPlaying Back CDs Loading CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Playing at Random Random Play Repeating Tracks or CDs Repeat PlayProhibiting Disc Ejection Tray Lock Prepare CDsPlaying Back a Tape Playing Back TapesLocating the Beginning of a Song Music Scan Using Dolby Surround Preparing for Dolby SurroundEnjoying Playback with Dolby Surround Recording Recording Tapes on Deck BStart recording. On the unit Press REC START/STOP To protect your recordingDubbing Tapes CD Direct RecordingTo cancel Auto Edit Recording Auto Edit RecordingTo change the tape length manually To stop during Auto Edit RecordingUsing the Timers Using Daily TimerUsing Recording Timer When selecting CDWhen selecting Tuner FM or Tuner AM Press 4or ¢to set the volume levelUsing Sleep Timer Timer PriorityMaintenance Additional InformationDescription of the PTY codes Handling discsTroubleshooting SymptomSpecifications EN, CZ, PL, HU 0599AOMQDSJEM