JVC CA-MXJ75R manual Using Recording Timer, When selecting CD, When selecting Tuner FM or Tuner AM

Page 31

Continued

English

6 When selecting “– CD – – –”

1)Press 4or ¢ to select the disc number, then press SET.

2)Press 4or ¢ to set the track number, then press SET.

The unit enters volume setting mode.

When selecting “TUNER FM” or “TUNER AM”

Press 4 or ¢ to select the preset station number, then press SET.

The unit enters volume setting mode.

7 Press 4or ¢to set the volume level.

PRESET

SEA CONTROL

SET

PRESET

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “0,” and starts recording

when the on-time comes (the indicator flashes just before the on-time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” appears just before the off-time), the unit automatically turns off (stands by).

The timer setting remains in memory until you change it.

• There is a time limit in doing the following steps. If the

• You can select the volume level from

among four levels. If you select “ VOL – – –,” the volume is set to the last level when the unit has been turned off.

setting is canceled before you finish, start from step 1

again.

• If you have made a mistake while setting the timer, press

CANCEL. (However, this does not always work. If

CANCEL does not work, press TIMER/CLOCK repeatedly

DAILY

8 Press SET to complete the Daily Timer setting.

The DAILY indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence.

SEA CONTROL

SET

STANDBY

and start from step 1 again.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press TIMER/CLOCK until “REC”

TIMER

appears on the display.

/CLOCK

 

The REC indicator also starts flashing on the display.

9 Press to turn off the unit (on standby) if you have set the Daily Timer with the unit turned on.

To turn on or off Daily Timer after its setting is done

REC

1Press TIMER/CLOCK repeatedly until “DAILY” appears on the display.

2To turn off the Daily Timer, press CANCEL. The DAILY indicator goes off from the display. The Daily Timer is canceled, but the setting for the Daily Timer remains in memory.

To turn on the Daily Timer, press SET.

The DAILY indicator lights up on the display. The settings you have done are shown on the display in sequence for your confirmation.

TIMER /CLOCK

DEMO

CANCEL

SEA CONTROL

SET

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled

 

Clock

 

ON TIME

 

 

 

 

setting

 

 

(See page 10.)

 

3 Press TIMER/CLOCK again.

TIMER

“ON TIME” appears for 2 seconds, then the

/CLOCK

 

unit enters on-time setting mode.

 

REC

 

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

REC

– 26 –

Page 30 Page 32
Image 31
Page 30 Page 32
Contents CA-MXJ75R Power can be remote controlled Page CA-MXJ75R Class Laser Product Introduction PrecautionsAbout This Manual Contents Location of the Buttons and Controls Powered Rolling PanelBecome familiar with the buttons and controls on your unit Disc number buttons and lamps CD 1, CD 2, and CD 3 Front PanelDisplay Window See pages in the parentheses for detailsFM/AM button Remote ControlRemote Control AUX buttonFM antenna Connecting AntennasGetting Started UnpackingTo connect front speakers Connecting SpeakersRelease the finger from the clamp AM MW/LW antennaTo connect a subwoofer Connecting Other EquipmentTo connect a center speaker and rear speakers To connect an analog componentTo stop the demonstration, press any button Press and hold Demo for more than 2 secondsTo start the display demonstration manually To stop the display demonstration, press any button onCommon Operations Setting the ClockTurning On the Power and Selecting the Sources Adjusting the VolumePress Balance L/R button On the remote control onlyReinforcing the Bass Sound Press and hold ShiftCreating Your Own Sound Mode Manual Mode Tuning in a Preset Station Tuning in a StationPresetting Stations Searching for Programs by PTY Codes PTY Search Receiving FM Stations with RDSChanging the RDS Information Press Select / + until the EON Switching to a Program Type of Your Choice TemporarilyPress PTY/EON until EON Select alternately appear on the displayBasic CD Operations Playing Back CDsLoading CDs Playing Back the Entire Discs Continuous PlayProgram Play Prepare CDs Playing at Random Random PlayRepeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Tray LockPlaying Back a Tape Playing Back TapesLocating the Beginning of a Song Music Scan Preparing for Dolby Surround Using Dolby SurroundEnjoying Playback with Dolby Surround To protect your recording RecordingRecording Tapes on Deck B Start recording. On the unit Press REC START/STOPCD Direct Recording Dubbing TapesTo stop during Auto Edit Recording To cancel Auto Edit RecordingAuto Edit Recording To change the tape length manuallyUsing Daily Timer Using the TimersPress 4or ¢to set the volume level Using Recording TimerWhen selecting CD When selecting Tuner FM or Tuner AMTimer Priority Using Sleep TimerHandling discs MaintenanceAdditional Information Description of the PTY codesSymptom TroubleshootingSpecifications EN, CZ, PL, HU 0599AOMQDSJEM
Top Page Image Contents