While using one of the surround modes
You can adjust the rear speaker output level if the rear speakers are connected. Once you adjust the rear speaker output level for each surround mode, the adjusted level is stored in memory.
•You cannot adjust the right and left rear speaker levels separately.
English
2 | PRESET |
Adjust the SEA pattern. |
1)Press 4or ¢to select the frequency range to adjust
(LOW, MID, HIGH). | TUNING |
2) Press 1or Áto adjust the |
level |
On the remote control ONLY: 1 Press and hold SHIFT.
2 Press REAR LEVEL
•Pressing REAR LEVEL – decreases the output level (from +10 to
•Pressing REAR LEVEL + increases the output level (from
SHIFT
– LEVELREAR +
frequency range. |
3) Repeat steps 1) and 2) to adjust the level of |
the other frequency ranges. |
3 | Press SEA CONTROL again. | SEA CONTROL | |
SET | |||
|
|
3 Release SHIFT.
Creating Your Own Sound Mode — Manual Mode
You can change SEA pattern to suit your preference. These changed settings can be stored in the MANUAL 1, 2, and 3 modes.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
•If you want to add the surround elements in your SEA pattern, select one of the surround modes (D.CLUB, HALL, or STADIUM) before starting the procedure below.
On the unit ONLY:
1 Press and hold SEA CONTROL until SEA CONTROL
SET
“SEA CONT” appears on the display.
4 Press 4or ¢to select one of the
MANUAL 1, 2, and 3 modes into which you want to store the SEA pattern.
5 Press SEA CONTROL again. | SEA CONTROL |
SET | |
| SOUND MODE |
The SOUND MODE indicator also lights up.
The SEA pattern you have created are stored into the MANUAL mode selected in the above step.
To use your own sound mode
Select MANUAL 1, 2, or 3 mode when using the sound modes. See “Selecting the Sound Modes” on page 11.
If you have stored your MANUAL 1, 2, and 3 modes with the surround elements
You can also adjust the rear speaker output level. See “While using one of the surround modes”.
Current level appears.
– 12 –