JVC CA-MXJ75R manual Enjoying Playback with Dolby Surround

English

4 ONLY FOR “PR O LOGIC”

Press DELAY TIME repeatedly to	DELAY TIME
select the proper delay time of the
rear speaker output.

•Each time you press the button, the delay time changes as follows.

DELAY1 DELAY2

DELAY4 DELAY3

DELAY1: Select this when the distance from you to your rear speakers is greater than that to the front speakers.

DELAY2: Select this when the distance from you to your rear speakers is almost equal to that to the front speakers.

DELAY3: Select this when the distance from you to your rear speakers is less than that to the front speakers.

DELAY4: Select this when the distance from you to your rear speakers is much less than that to the front speakers.

5 Press TEST TONE to check the			TEST TONE
speaker output balance.
A test tone comes out of the speakers in the
following order:		CENTER *
	LEFT
	(Left front speaker)	(Center speaker)
	SURROUND	RIGHT
	(Rear speakers)	(Right front speaker)

*“CENTER” does not appear when selecting “PHANTOM” or “OFF” for the center mode, and no test tone comes out of the center speakers.

6 Press VOLUME + / – to adjust + the test tone volume to a proper

level.–

7 If necessary, adjust the speaker output balance so that the output level from center and rear speakers is almost equal to that from the front speakers:

To adjust the center speaker output level	– CENTERLEVEL +
(from –10 to +10),press CENTER LEVEL
– / +.
• You cannot adjust the center speaker
output level when you select
“PHANTOM” or “OFF” for the center mode.
To adjust the rear speaker output level	– LEVELREAR +

(from –10 to +10),press REAR LEVEL – / +.

• You cannot adjust the right and left speaker output levels separately.

• You cannot adjust the rear speaker output level when using Dolby 3 Stereo.

8	Press TEST TONE again to stop the	TEST TONE
	test tone.
9	Release SHIFT.

Enjoying Playback with Dolby Surround

You can use the settings you have already stored in memory.

On the unit:

1	Press PRO LOGIC / 3 STEREO to	PRO LOGIC
		/ 3 STEREO

select the Dolby Surround mode you want.

The PRO LOGIC or 3 STEREO indicator lights up on the display

• Each time you press the button, the Dolby Surround modes changes as follows:

PRO LOGIC 3 STEREO

Canceled

•When Dolby Surround is activated, the sound mode is canceled temporarily.

2 Select and play a sound source encoded with Dolby Surround (with the DOLBY SURROUND mark).

To cancel the Dolby Surround mode, press PRO LOGIC / 3

STEREO repeatedly until neither PRO LOGIC nor 3 STEREO indicator remains lit on the display.

On the remote control:

1		SHIFT
	Press and hold SHIFT until the
	following procedure is finished.
2	Press PRO LOGIC or 3	PRO LOGIC 3 STEREO
	STEREO whichever you
	want to use.

The PRO LOGIC or 3 STEREO indicator lights up on the display.

•When Dolby Surround is activated, the sound mode is canceled temporarily.

3 Select and play a sound source encoded with Dolby Surround (with the DOLBY SURROUND mark).

To cancel the Dolby Surround mode, press PRO LOGIC or 3 STEREO (the same button you have pressed to activate Dolby Surround in step 1 above) so that neither PRO LOGIC nor 3 STEREO indicator remains lit on the display.

– 21 –