JVC SR-DVM700U manual Insert Editing DV Deck Only, If the player has no S-VIDEO output connector

Insert Editing (DV Deck Only)			EDITING EN 57
			● Slide the TV/DVD switch to DVD.
Insert Editing replaces the pictures with new ones, while the audio			1 Make connections.
soundtrack remains unchanged. For Insert Editing, use your unit			A If the player has no S-VIDEO output connector:
			^ connect the player’s VIDEO OUT connector to your unit’s
as the recording deck.
			[VIDEO] input connector on the front panel.
ATTENTION:			B If the player has an S-VIDEO output connector:
			^ connect the player’s S-VIDEO OUT connector to your unit’s
Insert Editing is not possible with a Mini DV cassette recorded in
			[S-VIDEO] input connector on the front panel.
LP mode.
			2 Load a Mini DV cassette with the erase protection switch set to
A If the player has no S-VIDEO output connector:			ARECB.
			3 Press DV/HDD/DVD on the unit repeatedly or DV on the remote
	INPUT SELECT
Your unit		Recorder	so that the DV lamp lights up on the unit.
			4 Press INPUT SELECT +/– on the remote control or
			INPUT SELECT on the unit to select AF-1B.
			5 Press S, T and W to determine the edit-in point (the
			beginning of the segment to be replaced).
			● Be sure to engage the Still mode at the edit-in point.
	To [VIDEO] input	INSERT	6 Press INSERT to engage the insert editing mode.
			● Your unit enters the Insert Pause mode.
			● The TV screen changes from the still picture to the input source
			you are going to record.

Audio/video cable

(not supplied)

7Load the source cassette and play back the segment that is to be inserted. When you reach the start of the section of the source tape that you wish to insert, press I to start the tape in your unit. Insert editing begins at this point.

8Press o to stop recording on the DV deck to end insert editing.

VIDEO OUT

Another recorder

Player

BIf the player has an S-VIDEO output connector:

Your unit	INPUT SELECT	Recorder
To [S-VIDEO]		INSERT
input

NOTES:

●All necessary cables can be obtained from your dealer.

●Insert Editing cannot be performed on a Mini DV cassette that has had its erase protection switch set to ASAVEB.

●When Insert Editing is performed on a tape that has been recorded on another video recorder, the inserted portion may appear distorted.

●A small portion of the recording which precedes an insert edit may become erased.

●Insert Editing is not possible using the [DV IN/OUT] connector.

●Insert Editing is not possible on a blank portion of the tape.

S-video cable (not supplied)

S-VIDEO OUT

Another recorder

Player