JVC SR-DVM700U manual When you can’t switch the audio channel of a bilingual, Program

Page 59

 

 

SYSTEM CONNECTIONS EN 59

Connecting To A Dolby Digital Decoder

1 Connect the unit and a Dolby Digital Decoder or an amplifier

with built-in DTS using either an optional optical cable or an

Or An Amplifier With Built-in DTS

optional coaxial cable.

NOTES:

These instructions enable you to connect your unit to a Dolby

● For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY

DIGITAL/PCMB. (A pg. 60)

Digital Decoder or an amplifier with built-in DTS.

● For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB.

 

 

 

 

(A pg. 60)

 

 

CAUTIONS:

 

 

● This unit has a dynamic range of more than 110 dB with regards

 

 

to its Hi-Fi audio capability. It is recommended that you check the

 

 

maximum level if you are going to listen to the Hi-Fi audio signals

 

 

through a stereo amplifier. A sudden surge in the input level to

 

 

the speakers may damage them.

 

 

● Some speakers and televisions are specially shielded to prevent

 

 

television interference. If both are of the non-shielded type, do not

Dolby Digital Decoder or

 

place the speakers adjacent to the TV set as this can adversely

 

affect the playback picture.

amplifier with built-in DTS

 

 

 

To DIGITAL AUDIO input

When you can’t switch the audio channel of a bilingual

 

program

 

 

 

 

When the unit is connected with a digital audio device using an

Coaxial cable

Optical cable

optional optical cable and ADIGITAL AUDIO OUTB is set to

(not supplied)

(not supplied)

ADOLBY DIGITAL/PCMB, it is not possible to switch the audio

 

 

channel of a bilingual program recorded on a DVD-RAM or DVD-R/

To [DIGITAL AUDIO

To [DIGITAL AUDIO

RW (VR mode) disc. In this case, perform the following steps using

OUTPUT

OUTPUT (OPTICAL)]

the remote control to switch ADIGITAL AUDIO OUTB from ADOLBY

(COAXIAL)]

 

DIGITAL/PCMB to APCM ONLYB.

 

 

A Press SET UP to access the Main Menu screen.

 

 

B Press selection keys to select ADVD VIDEO SET UPB, then

 

 

press G.

 

 

C Press selection keys to select AAUDIO OUTPUTB, then press

 

 

G.

 

Rear of unit

D Press selection keys to select ADIGITAL AUDIO OUTB, then

 

press ENTER.

 

 

 

 

E Press selection keys to select APCM ONLYB, then press

 

 

ENTER. (A pg. 60)

 

 

F Press SET UP to complete the setting.

 

 

G Press AUDIO to select the desired audio channel.

Note for connection:

Remove the protection cap from the optical cable.

Page 58 Page 60
Image 59
Page 58 Page 60
Contents For Customer Use SR-DVM700UJVC Dear CustomerDeclaration of Conformity SR-DVM700UOutdoor Antenna Grounding Power LinesPower Sources Power Cord ProtectionReplacement Parts AccessoriesCleaning Damage Requiring ServiceDo not block the unit’s ventilation openings or holes Do not place the unitContents After finalizing About DiscsDVD-R/RW Discs Before finalizingRegion Number Discs For Playback OnlyUnplayable Discs DVD-RAM Recording Medium And FormatFile Structure Of Discs DVD Video Marks Care And Handling Of Discs Life Span Of PartsC D E F G H I K L M Front ViewRear View AC Power Cord a pg Cooling FanSerial Command Connector D-SUB 9-PIN Serial COM. a pg VIDEO/VIDEO/AUDIO Output Connectors HDD & DVD deck onlyFront Display Panel HDD Button* a pg Remote ControlHow To Use TV Muting Button TV d a pg DV Button* a pgWhen recording When pressing REC ModeWhen playing back a recorded title When using Live Memory playbackConnected DV equipment information When capturing images from the external DV equipmentOn-Screen Display DV Dubbing On-Screen Display DV deckBasic Connections Connecting to a TV MonitorConnecting to a DV Device Connecting to Another RecorderDaylight Saving Time Clock SetPress selection keys to set EnterMenu/Audio/Subtitle Language Set DVD deck only LanguageOn-screen Language Set Pan&Scan Monitor SetAmonitor TYPEB, then Pan&Scan/Letter BoxBasic Playback Slow Motion Playback FeaturesVariable Speed Search Still Picture/Frame-By-Frame PlaybackJump Search Skip Search Resume FunctionInstant Replay DVD-RAM/DVD-R/DVD-RW Marking Positions To Play Back Again LaterChecking The Time Information Angle SelectionTrack USE Subtitle Selection Audio Language/Sound SelectionAudio Channel Selection Playback Control PBC FunctionRepeat Playback How To Access The On-screen BarContents of the on-screen bar during playback Basic Operation On The On-screen BarJPEG/MP3 Locating The Beginning Of a Desired SelectionDVD-RAM/RW/R Time Search Adjusting The Picture QualitySimulated Surround Effect Program Playback Setting The Progressive ModeRandom Playback Skip Search Basic Playback Playback FeaturesMarking Positions To Play Back Again Later 5x Speed PlaybackAccidental erasure prevention Usable cassettesFor Automatic Start Of Playback Next Function MemorySoundtrack Selection Time CodeRecording/playback Status Display Live Memory PlaybackForward Jump Available only when pausedNavigation EE Check Backward JumpHDD RetroActive Recording HDD deck onlyResuming Playback HDD deck only About limitation on temporary recordingIcons and their meanings Library Database NavigationAbout registration of information Keys Limitations of registrationTitle Name Edit Original InformationScan For Beginning Of Title Modify IndexTo modify the points Modify CategoryProtect Title Delete TitleSelection keys to select Modify Chapter HDD, DVD-RAM & DVD-R/RW VR mode onlyDivide Title HDD deck only Play List Edit Play List InformationCreate Play List Edit ScenesPlay Back Play List Add scenesMove Scenes Delete ScenesRegister Disc Navigate Library InformationScan For Title From Library Press Navigation Locating The Desired Folders And TracksManual Dubbing From HDD To DVD DubbingHigh Speed Dubbing From HDD To DVD Just Dubbing From HDD To DVDArec B Dubbing From DVD To DVDubbing From HDD To DV Original Dubbing From DVD To HDDDubbing a Part of a Cassette Dubbing From DV To HDDDubbing An Entire Cassette Dubbing From DV To DVDAbout Disc Remaining Display Completedb appears on the TV screen when the tape end isWhen performing the Just Dubbing When performing the Manual DubbingAuto capture button Remote control switchSound monitor switch To skip unwanted part of the source picture When you dub from DV equipment other than a camcorderRecording Mode Free Rate FunctionEdit From a Camcorder If the camcorder has no S-VIDEO output connectorIf the camcorder has an S-VIDEO output connector If the camcorder has a DV IN/OUT connectorWhen using your unit as the recording deck When using your unit as the source playerDubbing DV Format Contents To a DV Device HDD Deck Only Example Dubbing to an MD Digital Audio DubbingAudio Output Audio Dubbing DV Deck OnlyArecb Input Select on the unit to select AF-1BInsert Editing DV Deck Only If the player has no S-VIDEO output connectorIf the player has an S-VIDEO output connector Brand Name Code Remote Control FunctionsRemote Control 1/2/3/4 Code Switching TV Multi-Brand Remote ControlProgram When you can’t switch the audio channel of a bilingualMode Set To record in Dolby Digital format Original recorded soundPost-recorded sound Original recorded sound and post-recorded soundYou can select the desired sound mode when playing back an To display the ADV SET UPB menu, press SET UP whileDV deck mode Enables Audio Dubbing laterFormat a DVD-R Disc Format a Disc DVD Deck OnlyFormat a DVD-RAM Disc Format a DVD-RW DiscFinalize a Disc DVD Deck Only After finalizing For DVD-R/RW Video mode discsTo finalize a disc Cancel The Finalization Of a DVD-RW DiscTo cancel finalization Background and text color Text ColorUpdating Backgrounds And Text Color Usable image format, text format and discPreviewing the background effect Registering Default Background And Text ColorTo lock tray Mode LockTray Lock DVD Deck Only Last Function MemoryPlayback DV Deck Initializing DVD Deck OnlyGeneral Playback HDD DeckFor component video connection Recording HDD DeckRecording DV Deck For basic connectionRecording and/or editing cannot be performed Damaged. Take out the disc, clean it and retry. a pgOperation has been attempted when a disc is not loaded, or Formatting is not complete since the disc may be dirty orLanguage Code List PIN No RS-232C Interface Command TableRS-232C Interface Specifications 9PIN D-SubCommand Description RS-232C Interface CommandOperation Commands REW Ones Clock PresetSET UP Power ON/OFFTEN KEY REC REC Mode SP/LP/EP… REC Pause DVD Deck Return DV/HDD/DVD Dubbing JOG-1 CancelExternal input selection B8 Input/Output Selection 1st Byte 2nd ByteVideo B8 Audio Language Selection 1st Byte 2nd Byte See ALanguage Code ListB a pgB8 Subtitle Selection 1st Byte 2nd Byte Response Commands System CommandsTime Sense Subtitle selectionDate Sense Pause D7 StatusSense HDD DVD HDD/DVD VTRDVD DVD-RAM DVD-RW DVD+R DVD+RW VCD DD JVCPause Type Pause Disc TypeTemperature Power requirement Video recording compression systemPower consumption Audio recording system Laser specification Recording timeStill Picture/Frame-By-Frame Playback Simultaneous Recording and PlaybackMemo EN SR-DVM700U

SR-DVM700U specifications

The JVC SR-DVM700U is a versatile and high-performance digital video recorder that caters to both professional and consumer needs. It is designed to handle a variety of video formats, making it a convenient and reliable choice for video production, archiving, and playback tasks.

One of the standout features of the SR-DVM700U is its ability to support both digital and analog formats. It can play and record from MiniDV, DVCAM, and DVCPRO tapes, while also offering the capability to handle various VHS formats. This dual functionality provides users with an excellent solution for converting older tapes to digital formats while maintaining high-quality output.

In terms of connectivity, the SR-DVM700U is equipped with a range of inputs and outputs. It features FireWire (IEEE 1394) connectivity, enabling fast and efficient transfer of digital video to and from computers and other devices. Additionally, it has multiple composite video and audio connections, making it easy to interface with various equipment in the production setup. The S-Video and component outputs enhance the video quality, ensuring professional-grade performance.

The device leverages advanced digital processing technologies to ensure high-quality audio and video recordings. It includes a built-in up-converter that improves the resolution and sharpness of analog signals when converting to digital formats, enhancing the overall viewing experience.

The JVC SR-DVM700U also incorporates features like playback time code and edit search functions, which are essential for video editing workflows. This technology allows users to efficiently navigate through their footage, making it easier to locate specific scenes or segments during the editing process.

Moreover, the unit is designed with a user-friendly interface, featuring a clear LCD screen and easy-to-use controls, which facilitate seamless operation. The compact and robust design ensures durability, making it suitable for both studio environments and on-location shoots.

In summary, the JVC SR-DVM700U digital video recorder is a powerful tool that combines multiple recording formats, advanced processing technologies, and versatile connectivity options. Its ability to bridge the gap between analog and digital media, coupled with its professional features, makes it an invaluable asset for videographers and multimedia professionals looking to preserve and transform their video content.
Top Page Image Contents