JVC GM-F520S, GM-F470S Self-diagnostic indication, Self-diagnostic Report Sheet, TEMP. Over

Self-diagnostic indication

When something abnormal occurs with the monitor, this function informs you of the condition of the monitor with the self-diagnostic lamps, allowing for smooth service work.

If the trouble still persists, follow the procedure below:

1 Check which lamps are lit or flashing.

On the Self-diagnostic Report Sheet (below), check the box next to “Lights” or “Flashes” of the

corresponding lamp or lamps.

• Only one lamp may light or flash, or all three lamps may do so.

“TEMP. OVER” appears here.

Self-diagnostic lamps

If the monitor screen turns off and the self- diagnostic lamps light or flash

If the self-diagnostic lamps light or flash in red, check the following before consulting the dealer where you purchased the monitor.

•If the self-diagnostic lamp 1 lights, lamp 2 flashes, and lamp 3 lights.

This may be caused by the dusty intakes on the rear and top. If this happens, switch off the main power using the power switch (set to “‡ (off)”), unplug the AC power cord, then clean the intakes by referring to the instruction on page 3.

After cleaning, switch on the monitor’s main power again. If the self-diagnostic lamps do not go off, consult your dealer immediately.

If the monitor screen dims a little and “TEMP. OVER” appears (or flashes)

If “TEMP. OVER” appears or flashes at the left top of the screen, check the following before consulting the dealer where you purchased the monitor.

“TEMP. OVER” appears to warn you of internal heat buildup, which is usually caused by accumulated dust around the intakes or by improper installation. If the cause of the internal heat buildup is eliminated, this indication disappears and the screen returns to normal brightness.

•If “TEMP. OVER” flashes in yellow

This may be caused by the dusty intakes on the rear. If this happens, switch off the main power using the power switch (set to “‡ (off)”), unplug the AC power cord, then clean the intakes by referring to the instruction on page 3.

–After cleaning, switch on the monitor’s main power again. If “TEMP. OVER” still flashes, this problem may be caused by improper installation or improper location of the monitor. In this case, consult your dealer immediately to solve this improper installation and to improve the circumstances around the monitor.

•If “TEMP. OVER” appears in red

“TEMP. OVER” will be shown for about two minutes, the monitor will shut off automatically, then the self-diagnostic lamps light in red. If this happens, switch off the main power using the power switch (set to “‡ (off)”), unplug the AC power cord, then consult your dealer immediately.

2	Switch off the POWER switch on the back of the monitor.
3	Unplug the power cord.
4	Call your dealer and tell them which lamps are lit or flashing. (Copy and fax the Self-diagnostic Report
	Sheet below.)

NOTE

•If you switch on the main power immediately after switching it off (or after recovering from a brief power interruption), the self-diagnostic lamps may light (or flash), and no image may appear on the screen. In this case, switch off the main power again, wait for about 10 seconds, then switch it on again. If no self- diagnostic lamps light or flash, you can operate and use the monitor as usual.

Self-diagnostic Report Sheet

Store name where you purchased the monitor

To

Model name: LCD DISPLAY MONITOR

GM-F520S/GM-F470S/GM-F420S

The self-diagnostic lamps light or flash as listed on the following table. Please give me immediate advice or service if necessary.

Self-diagnostic lamp

No.	Lamp position	Conditions
1	Upper	& Lights	& Flashes
2	Middle	& Lights	& Flashes
3	Lower	& Lights	& Flashes
TEMP. OVER		& Lights	& Flashes
Your Name
Telephone
No.:
Address:

27