Safety Instructions
Safety Instructions
Please take note of the safety instructions to prevent any potential accident or misuse of the projector.
➟Safety Instructions are given in two forms as detailed below.
WARNING : The violation of this instruction may cause serious injuries and even death.
NOTES : The violation of this instruction may cause light injuries or damage to the projector.
➟After reading this manual, keep it in the place that the user always can contact easily.
| Indoor Installation | WARNING |
|
|
|
Stand the projector when you | Do not place the Projector in direct |
install. | sunlight or near heat sources such |
If not, the power turns off. | as radiators, fires and stove etc. |
| |
| This may cause a fire hazard ! |
Do not allow children to hang on the installed projector.
It may cause the projector to fall, causing injury or death.
Do not place inflammable materi- als beside the projector
This may cause a fire hazard !
| Indoor Installation | NOTES |
|
|
|
Disconnect the power and remove all connections before moving.
Do not place the projector close to sources of steam or oil such
as a humidifier.
This may create a fire hazard or an electric shock hazard !
Do not place the projector where it might be exposed to excessive dust.
This may cause a fire hazard !
Only use the projector on a level and stable place.
It may become unstable and affect operation.
Ensure good ventilation around the projector. The distance between the projector and the ceiling or bottom should be more than 20cm/8 inches.
An excessive increase in its internal temperature may cause a fire haz- ard!
Do not block the vents of the pro- jector or restrict
This would cause the internal tempera- ture to increase and could cause a fire hazard!
Do not place the projector directly on a carpet, rug or place where ventilation is restricted.
This would cause its internal temperature to increase and might create a fire hazard !
| Outdoor Installation | WARNING |
|
|
|
Do not use the projector in a damp place such as a bathroom where it is likely to get wet.
This may cause a fire or an electric shock hazard !
| Power | WARNING |
|
|
|
Earth wire should be connected.
If the earth wire is not connected, there is a possible danger of electric shock caused by the current leakage.
If grounding methods are not possible, a separate circuit breaker should be employed and installed by a qualified electrician.
Do not connect ground to telephone wires, lightning rods or gas pipe.
The mains plug should be insert- ed fully into the power outlet to avoid a fire hazard !
This may cause a fire hazard !
Do not place heavy objects on the power cord
This may cause a fire or an electric shock hazard !
4