Honeywell setup guide Optiflex Status LEDs, Camera Activity

Page 16

Optiflex Installation and Setup Guide

Optiflex Status LEDs

Camera Status

Off – All detected cameras are connected

Flashing – At least one camera lost.

Camera Activity

On – At least one camera is detected

Off – No cameras detected

Flashing – At least one camera is being viewed

Power

On – power applied to Optiflex

Off – No power applied to Optiflex

NOT

USED

CAMERA

STATUS

CAMERA

ACTIVITY

POWER)

optiflex-006-V0

4-2

Image 16

Contents ADEMCO Optiflex Page Table of Contents Page Optiflex Features General FeaturesGeneral Information Introduction to OptiflexOptiflex Typical System Block Diagram Mounting, Wiring, and Setup Setup ConsiderationsOutput Command 4204 on ECP Address Function Voltage Trigger FunctionMounting Optiflex Mounting OptiflexWiring and Setup of Optiflex Header ConnectorMake Sure ALL System Grounds are Connected Together Ntsc Output Configuration Ntsc Guard Tour Mode Camera Scanning Mode Camera Dwell TimeDip Sec 16 sec Switch TourOptiflex Installation and Setup Guide Setting Up Optiflex Using Symphony How to Enable Video on SymphonyHow to Set Up Video Options on Symphony Camera Status LEDs Operational Status IndicatorsNetwork Status LEDs Optiflex Status LEDs Camera ActivitySpecifications SpecificationsOptiflex Installation and Setup Guide Trigger Data DIP Switch Settings Ntsc Output Configuration DIP Switch 1Ntsc Guard Tour Mode Camera Dwell Time Ntsc Guard Tour Mode Camera SelectionOptiflex Installation and Setup Guide Page Page Limited Warranty ÊK0948V2pŠ