Honeywell setup guide Optiflex Typical System Block Diagram

Page 6

Optiflex Installation and Setup Guide

Optiflex Typical System Block Diagram

A typical Optiflex System Block Diagram is shown in Figure 1. Optiflex can be used in a variety of applications. It can be:

•connected through an Ethernet hub/router to a PC or Symphony for remote viewing

•programmed in the control panel to be triggered by selected events of the security system, and viewed locally on a Symphony connected to the security system control panel

•used as a standalone system with only a monitor or a Symphony for local viewing

•configured for all of the above.

Figure 1. Optiflex System Block Diagram Showing Possible Configurations

1-2

Image 6

Contents ADEMCO Optiflex Page Table of Contents Page General Information Optiflex FeaturesGeneral Features Introduction to OptiflexOptiflex Typical System Block Diagram Output Command 4204 on ECP Address Function Mounting, Wiring, and SetupSetup Considerations Voltage Trigger FunctionMounting Optiflex Mounting OptiflexWiring and Setup of Optiflex Header ConnectorMake Sure ALL System Grounds are Connected Together Dip Sec 16 sec Switch Ntsc Output ConfigurationNtsc Guard Tour Mode Camera Scanning Mode Camera Dwell Time TourOptiflex Installation and Setup Guide Setting Up Optiflex Using Symphony How to Enable Video on SymphonyHow to Set Up Video Options on Symphony Operational Status Indicators Camera Status LEDsNetwork Status LEDs Optiflex Status LEDs Camera ActivitySpecifications SpecificationsOptiflex Installation and Setup Guide Ntsc Guard Tour Mode Camera Dwell Time Trigger Data DIP Switch SettingsNtsc Output Configuration DIP Switch 1 Ntsc Guard Tour Mode Camera SelectionOptiflex Installation and Setup Guide Page Page Limited Warranty ÊK0948V2pŠ