How to Use the SOURCE SELECT Button
INPUT ACCESS
This optional feature allows the user of the remote control to setup it’s SOURCE SELECT button to access the specified input of the TV. Setup for this feature is applicable to the remote control’s normal mode only and only applies to the DVD, PVR/VCR and SAT/CBL modes.
1.Select the desired device mode (DVD, PVR/VCR, SAT/CBL) by using your SOURCE SELECT button to position the LED indicator to the corresponding selection.
2.Hold down the SOURCE SELECT button on the remote and enter the four digit preset code that matches your device as shown on pages
3.Then enter the assigned input number
4.Release the SOURCE SELECT button.
5.If done correctly, the device LED indicator will blink 3 times to confirm proper setup.
6.The remote will now control the desired device.
7.Pressing the INPUTS button will now access the video input of the desired device.
SETUP EXAMPLE (Hitachi DVD with precode 0573 connected to INPUT 1 of the TV)
Select DVD mode by using your SOURCE SELECT button to position the LED indicator to DVD.
Hold down the SOURCE SELECT button and press the numbers 0, 5, 7 and 3.
Then press the number 1 for the assigned input number of the DVD player.
, ,
,,
| Table 1 | |
|
|
|
INPUT |
| ASSIGNMENT NUMBER |
|
| |
INPUT 1 |
| 1 |
INPUT 2 |
| 2 |
INPUT 3 |
| 3 |
INPUT- FRONT |
| 4 |
HDMI 1 |
| 5 |
HDMI 2 |
| 6 |
HDMI- FRONT |
| 7 |
The Remote Control
Release SOURCE SELECT button. |
|
|
| NOTE: 1. | This feature is optional |
If done correctly, the device LED indicator will blink | 2. | Assigned input numbers can be used more |
3 times to confirm proper setup. |
| than once if applicable. |
The remote will now control the DVD player.
Press the INPUTS button to instantly access the video input of your DVD on Input 1.
31