Hitachi 32HLX61 important safety instructions Phones Jack

Page 10

FIRST TIME USE

FRONT PANEL CONTROLS

POWER button

Display Monitor “MAIN POWER” button

This power button is for the complete system, and must be turned ON/OFF manually. It is recommended to leave the “MAIN POWER” to ON condition (lights red) for stand-by mode.

STANDBY (RED) ON (GREEN) MAIN POWER

Back side view

The Main Power button is located on the Back side, under the label “MAIN POWER”.

AVC POWER button

The AVC power can be turned ON/OFF manually or by remote control. Turning on the AVC Power will only turn on the AVC box if the “MAIN POWER” of the display monitor is off.

POWER light indicator

To turn the monitor ON, press the main power switch located on the lower right side of the monitor. A red stand-by indicator lamp located on the lower right corner of the front bezel will illuminate. The LCD TV is now ready for remote on/off operation.

Indicating Lamp

Power Status

Operating

 

 

 

Off

Off

When the main power switch is set

 

 

OFF.

 

 

 

Lights Red

Off

When the main power switch on the display

 

(Stand-by)

monitor is ON, and the AVC Center is OFF.

 

 

 

Lights Green

On

Display monitor MAIN POWER is ON and

 

 

AVC Center power is ON.

 

 

 

Lights Orange

Off

Display monitor MAIN POWER is ON and

 

(Power Saving)

and AVC Center power is ON, with no signal

 

 

input except antenna (no sync. signal).

 

 

 

Flicking Green

The AVC is

When the MAIN POWER switch on the

(only in the AVC)

preparing to

display monitor is ON or OFF and the AVC

 

turn ON

 

center power is turning on.

 

 

 

 

 

REMOTE CONTROL sensor

Point your remote at this area when selecting channels, adjusting volume, etc.

FRONT INPUT JACKS (for VIDEO: 5)

Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording. Press the INPUTS button then use the CURSOR PAD and the SELECT button on the remote control to select INPUT 5. If you have mono sound, insert the audio cable into the left audio jack.

PHONES JACK

Use this jack for your head-phones. The TV’s internal speakers can also be heard. Turn off the internal speakers (see page 61) if you wish to listen to the head-phones only.

LEARNING AV NET Sensor

NOTES: 1. Your HITACHI LCD TV will appear to be turned OFF (lights orange) if there is no video input when VIDEO: 1, 2, 3, 4, 5, or RGB is selected. Check the Power Light to make sure the Display Monitor is turned off or in Stand-by mode (lights red) when not in use.

2.Remote Control can not turn ON/OFF the “MAIN POWER” of the display monitor.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Operating Guide for 32HLX61 Important Safety Instructions Do not OpenRead before operating equipment Public Viewing of Copyrighted MaterialTime AccessoriesUSE FirstSecuring to a wall HOW to Setup Your NEW Hitachi LCD TelevisionFirst Time USE AntennaBest HOW to SET UP Your NEW Hitachi LCD TelevisionViewing Vertical Viewing AngleHookup Cables First Time When both VHF and UHF antennas are connectedAntenna Connections to Rear Panel Jacks VHF 75-Ohm antenna/CATV Cable TVFront Panel Controls Photo InputPhones Jack Rear Panel Jacks Monitor OUTTo Power Swivel Connector SUB-POWER buttonUpgrade Card RGB Analog InputCableCARD Slot Rear Panel of AVCConnecting LCD Display Monitor to AVC BOX Connecting External Video Sources Connecting a Monaural Audio Source to INPUT1~INPUT5 Before Operating External Video SourceConnecting a Stereo VCR or Stereo Laserdisc Player Connecting S-VIDEO VCR or Laserdisc Player Hdmi input VideoDVI to Hdmi Input See page 28 for tips on Rear Panel Connections Digital VCR D-VHS Connecting External AUDIO/VIDEO Devices Connecting External Audio AmplifierConnecting AV Network Cursor Pads AV Network Setup WizardSetup Procedure Using AV Network Device Codes To set the Input to whichOFF or TV as Center Cursor PADTo set the Internal Speakers to On the connectionsAUDIO/VIDEO Codes for AV Network not for remote control Rear Panel Connections Time USETips on Rear Panel Connections Remote Control Remote ControlHOW to USE the Remote To Control Your LCD TV Standard Aspect buttonExpanded Menu button DAY/NIGHT buttonPICTURE-IN-PICTURE button Guide buttonControl AV NET buttonPress the Select button AV NET Learning WizardSelect the preferred TV Softkeys Ex Press Exit to QuitRemote Input Photo Input Ant BAnt a IeeeJump Slideshow RotateWhen an IEEE1394 device is connected Analog Channels When an S-VIDEOInfo button Digital ChannelsDash button Volume VOL WHEEL, Mute buttonChannel CH WHEEL/CHANNEL Selector buttons Last Channel LC buttonPICTURE-IN-PICTURE PIP POP Mode PICTURE-IN-PICTUREPress the Cursor PAD or to enable the sub-picture sound PIP buttonSurf Mode PICTURE-IN-PICTURE PIP Mode PICTURE-IN-PICTURESplit Mode PICTURE-IN-PICTURE NtscSplit Freeze Main FreezeStrobe Freeze Precoded Cable BOX buttons HOW to USE the Remote To Control Cable BOX FunctionsOperating the precoded function for your cable box Exclusive TV buttonsPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons Precoded DVD Buttons HOW to USE the Remote To Control DVD FunctionsOperating the precoded function for your DVD player These buttons transmit the chosen precoded DVD codesPrecoded VCR/PVR Buttons HOW to USE the Remote To Control VCR/PVR FunctionsThese buttons transmit the chosen precoded VCR/PVR codes Operating the precoded function for your Audio component HOW to USE the Remote To Control Additional Audio EquipmentPrecoded Audio Buttons Input Access VCR Brand Audio Brand Simple Remote OSD On-Screen Display ON-SCREEN DisplayVideo ForChannel Manager Locks Timers Setup Power Swivel Picture Mode VideoContrast Back LightReset Video Settings VideoNatural Noise Reduction Auto Movie ModeColor Decoding ANT A/B, Video 480p/720p/1080iAudio Language Digital Output AudioAuto Aspect AspectAspect Vertical PositionAuto Channel Scan Channel ManagerSet The Antenna Press Cursor PAD To highlight Ant a or Ant BSignal Meter Channel ListLocks Movie Ratings TV Ratings Eng Canadian RatingsCanadian Ratings English Table Programming is not suitable for children FrnCanadian Ratings French Table Programming restricted to adults ContainsTimers Set The ClockSet Sleep Timer Set Day/Night TimerSet Event Timer Please Set Clock FirstSet Timer Recording Display SetupMenu Preference Screen Image PowerMenu Background SaverSet The Inputs Video 2 Auto Link ON-SCREENSet Black Side Panel Set Closed Caption Auto will turn Display on when Mute/Soft Mute is onCaption Mode Caption Display On/Off will turn the display on or offCableCARD Info This feature will select the source of the Monitor OutputSet Monitor Out Set AV ControlSet Stand-By Mode UpgradesPower Swivel Vesa RGB on Screen DisplayVGA Using the RGB Input No SYNC. Signal Invalid Scan Freq This part of the screen Shows which RemoteUsing RGB InputContrast This feature allows you to adjust brightness in RGB ModeColor Temperature BrightnessBack Light ResetEnhancer AspectUsing PositionAdjusts the phase to correct blurred or unstable images Clock PhaseHorizontal Clock Input Level Using the RGBPower Swivel Black SideCare of Your Hitachi LCD Display Your Remote Control Do notGhosts Reception ProblemsIgnition Noise SnowSymptoms Useful InfoImportant Notes Picture Image SpectrumPlug and Play Trademark AcknowledgmentAgency Regulatory Information Outputs InputsRGB, Video Home Electronics Division Hitachi Way Chula Vista, CADigital Media Division Index Accessories23-26 END User License Agreement for Hitachi DTV Software Or the Software103 QR64521
Top Page Image Contents