HOW TO USE THE REMOTE
TO CONTROL YOUR LCD TV
AV NET LEARNING WIZARD
For example, after programming your AV Receiver to the AV NET and the soft keys do not work, the user has to use the AV NET Learning Wizard. The AV NET Learning Wizard will transfer any remote button IR code of your AV Receiver to the soft keys of your AV NET. Since an AVR2 (Custom) is not available in the device setup screen, the user can choose any custom device. For this setup example, we have chosen the PVR2 (Custom) device.
1. Press A/V NET button on the remote control.
2. Use the CURSOR PAD and to select DEVICE SETUP, press the SELECT button or CURSOR PAD .
3.Use the CURSOR PAD/SELECT button to choose CUSTOM option (Ex. PVR2).
4.Use the CURSOR PAD to select Setup, press the SELECT button.
5.Use the CURSOR PAD to select the prefered Softkeys (Ex. button) to learn, press the SELECT button.
10.A check mark appears next to the programmed softkey. Select DONE to EXIT or CONTINUE to learn another softkey.
11. Use the CURSOR PAD | to select Video Input. Press the | |
| CURSOR PADS | , to set the INPUT to which your |
device | is connected. | |
12.Repeat step 11 for Audio Input. If the AVR is connected to the TV, select “Using TV”. If the AVR is connected to an external amplifier, select “no connection”.
13. Press CURSOR PAD to select Transmission Test. Perform a Transmission Test by selecting Power, Play, or CH UP
softkeys. If the device responds, then it is properly set up. Select OK.
THE REMOTE
6. Press and hold the button of the AVR remote control while pointing directly at the learning AV NET sensor of the LCD Television (located behind the screen) at a distance of 2
to 3 meters or 5 to 10 feet.
7.If the code is not accepted, the screen below appears.
HITACHI AV NET WIZARD (Learning)
Transfer not completed!
Try again?
NO 
YES
Move SEL Select
8.If the code transfer was succesful, the screen below appears.
9.Select OK to continue.
14. Press Done.
15. Press Exit to Quit.
NOTES: 1. To access the Menu function of a specific equipment, select the “MENU” soft key on OSD, then press the MENU button of the LCD Television remote control. In order to use CURSOR PAD and EXIT button of the LCD Television remote control, “arrows, select, and EXIT” button must be learned. Then the menu of the programmed equipment can be controlled with the LCD Television remote control.
2.When using the Learned device with the Timer Recording function, the Power, Stop and Record soft Keys should be learned first.
CONTROL
35