Hitachi 32HLX61 Cursor PAD, To set the Internal Speakers to, OFF or TV as Center

AV NETWORK SETUP WIZARD

SETUP PROCEDURE USING AV NETWORK DEVICE CODES:

An AV Receiver Setup example is shown below. If your device is not listed or the device codes not work after following the setup procedure, please refer to the AV NET Learning wizard procedure on pages 33-35.

1.Press the A/V Net button on the remote control.

2.	Use CURSOR PADS and to highlight Device Setup.
3.	Press the SELECT button or CURSOR PADS on the
	remote control and the device selection screen appears.

4. Use the CURSOR PADS and to choose AV Receiver

and press the SELECT button on the remote control.

5.The Setup button on the bottom of the screen becomes highlighted. Press the SELECT button on the remote control to enter the setup screen.

6.Using the remote, enter the four digit Device Code for your equipment, found on page 26.

7.	Use the CURSOR PAD		to select AV Input. Press the
	CURSOR PADS and		to set the INPUT to which your
	device is connected.
8.	Use the CURSOR PAD		to select Internal Speakers. Press
	CURSOR PAD	and to set the Internal Speakers to
ON,	OFF or TV as Center.
9.	Press CURSOR PAD		to select Transmission Test. Press
	the CURSOR PADS	,	to select Power, Play, or CH UP

softkeys, before pressing the SELECT button to perform a Transmission Test of the softkey selected. If the device responds, then it is properly set up. Select OK. (If the Transmission Test failed, try another code.)

10.If “OK” was selected, and the 4 digit code was invalid, the screen below appears, then goes back to the Device

Code entry screen.

11.Repeat Device Setup procedure until the Source (SRC) Setting Screen appears.

This screen allows you to assign a label for each Source (SRC1 to SRC8) connection on the AV Receiver. Depending on the number of source connections to the AV Receiver, some sources may not be available.

12.	To label your sources, use CURSOR PAD and to
	highlight SRC1.
13.	Use CURSOR PAD and to select the Source (DVD,
	DVD2, VCR, VCR2, PVR, CBL, STB, TV or Custom). If
	SRC1 is active, video and audio will be available depending
	on the connections.

14.Repeat for SRC2 to SRC8 if applicable.

15.Select DONE to continue.

16. Select CONTINUE to setup another device.

17.Select DONE to finish and the screen below appears to show the device(s) which has been set-up.

FIRST TIME USE

18. Select EXIT to quit.

25