Hitachi 32HLX61 AV NET Learning Wizard, Select the preferred TV Softkeys Ex, Press Exit to Quit

HOW TO USE THE REMOTE

TO CONTROL YOUR LCD TV

AV NET LEARNING WIZARD

This function of the AV NET makes it more expandable because it allows the user to use equipment that is not supported by the AV NET Codes. For example, after programming your equipment to the AV NET and the soft keys do not work, the user just has to follow the steps below. The AV NET Learning Wizard will transfer any remote button IR code of your equipment to the soft keys of your AV NET. If all remote button transfers are successful, the user can now control their equipment by using the LCD Television remote control.

A Custom VCR Setup example is shown below. Setup of Custom DVD3, PVR2, CBL2 and STB2 follows the same procedure.

1.	Press A/V NET button on the remote control.	10. A check mark appears next to the programmed softkey.
2.	Use the CURSOR PAD and to select DEVICE SETUP,	Select DONE to EXIT or CONTINUE to learn another softkey.
	press the SELECT button or CURSOR PAD .

3.Use the CURSOR PAD/SELECT button to choose CUSTOM option (Ex. VCR3).

4.Use the CURSOR PAD to select Setup, press the SELECT

THE REMOTE CONTROL

Please choose the device to set up.

		( ) DVD			( ) Set Top Box
		( ) DVD2			( ) DVD3 (Custom)
		( ) VCR			( ) VCR3 (Custom)
		( ) VCR2			( ) PVR2 (Custom)
		( ) AV Receiver			( ) CBL2 (Custom)
		( ) PV Recorder			( ) STB2 (Custom)
		( ) Cable Box			List
		BACK		SETUP		MODIFY
	Move	SEL	Next Step
5. Select the preferred TV Softkeys (Ex.							button)to learn,

press the SELECT button.

HITACHI AV NET WIZARD (Learning)
Select the VCR3 softkey to learn?
	TV Softkeys
POWER
CH	CH	TV/VCR	MENU
			SELECT	EXIT
BACK
Move	SEL Select

6. Press and hold the button of the VCR remote control

while pointing directly at the learning AV NET sensor of the LCD Television (located behind the screen) at a distance of 2 to 3 meters or 5 to 10 feet.

HITACHI AV NET WIZARD (Learning)

Press and hold desired button to transfer the command to AV NET.

Please wait while AV NET

Learns the command...

7. If the code is not accepted, the screen below appears.

11. Use the CURSOR PAD		to select Video Input. Press the
	CURSOR PADS	, to set the INPUT to which your
device	is connected.

12.Repeat step 11 for Audio Input. If the DVD is connected to the TV, select “Using TV”. If the DVD is connected to an external amplifier, select “no connection”.

13. Press CURSOR PAD to select Transmission Test. Perform a Transmission Test by selecting Power, Play, or CH UP

softkeys. If the device responds, then it is properly set up. Select OK.

14. Press Done.

HITACHI AV NET WIZARD (Learning)

15. Press Exit to Quit.

Transfer not completed!

Try again?

NO YES

Move SEL Select

8.If the code transfer was succesful, the screen below appears.

9.Select OK to continue.

HITACHI AV NET WIZARD (Learning)

Transfer was successfull

Press OK to continue.

BACK	OK
Move	SEL Select

34