Extron electronic DDS 402 manual Button Labels, Installing labels in the scaler’s buttons

Page 52

Reference Information, cont’d

Button Labels

Figure A-4 provides blank button labels. If desired, photocopy them or cut them out of the manual, write button information in each button area as desired, and put them in the scaler’s input buttons’ windows.

Installing labels in the scaler’s buttons

Install new labels in the scaler’s front panel input buttons as follows:

1.Make new labels using either the blanks in figure A-4 or the Button-Label Generator software (see the chapter 5, Scaler Software). Cut them out.

2.Remove the button from the scaler by grasping the button firmly and pulling it away from the front panel.

3.Use a Tweeker to gently lever the button cap off of the white backing plate.

4.Insert a button label into the cap and gently but firmly press the cap onto the white backing plate.

5.Press the button into place in the scaler.

Use notch to remove button

Seperate two piece button here

Figure A-4 — Button label blanks

A-6 Digital Display Scaler • Reference Information

Image 52
Contents DDS Digital Display ScalerSafety Instructions English Consignes de Sécurité FrançaisSicherheitsanleitungen Deutsch Instrucciones de seguridad EspañolRear panel video outputs QS-1Default display cycle Quick Start DDS 402, cont’dMain menu Input menu QS-2Output menu Memory Presets menuQS-3 Advanced Configuration menu Picture Adjustments menuExecutive Mode menu Exit menuTable of Contents Table of Contents, cont’d Digital Display Scaler Table of Contents Iii Iv Digital Display Scaler Table of Contents One Introductiontroduction, cont’d About this ManualAbout the Scaler Digital Display Scaler IntroductionFeatures Introduction, cont’d Digital Display Scaler Introduction Introduction, cont’d Two Installationstallation, cont’d Installation OverviewMounting the Scaler Cabling and Rear Panel ViewsVideo input connections Video output connectionsInstallation, cont’d ConfigurationPower connection RS-232 connectionThree Front Panel Controls and Indicators Operationeration, cont’dFreeze button Input buttonsPicture adjustment buttons Adjustment knobsLCD display Menu control buttonsPower Operation, cont’dFront Panel Operations Button iconsConfiguration Input Configuration menuOutput Configuration menu Pixel Phase submenuInput #2 submenu Resolution and refresh rates submenu Resolution 50 Hz 56 Hz 60 Hz 75 Hz 85 Hz Lock at 50/60 HzOutput Signal submenu Sync Polarity submenuSave Presets submenu Erase Presets submenuBlue Mode submenu RGB Delay submenuEdge Smoothing submenu Test Pattern submenuPicture adjustments Reset submenuFront panel security lockout executive mode Adjust knobs have no mechanical limits to their rotationSetting up a DVD source Optimizing the VideoFour Symbols Digital Display Scaler Programmer’s GuideScaler-Initiated Messages RGB delay PresetsProgrammer’s Guide, cont’d Test patternUsing the Command/Response Table Scaler Error ResponsesHost-to-Scaler Instructions Command/response table for SIS commands Command Ascii Command Response Additional descriptionCommand/response table for SIS commands cont’d Test pattern Command/response table for special function SIS commands Command Ascii Command ResponseProgrammer’s Guide, cont’d Five Installing the software Using the control programControl Software for Windows Digital Display Scaler Scaler SoftwareUsing the help program Control program I/O configuration windowScaler Software, cont’d Using the softwareButton Label Generator AAppendix a Specifications Digital Display Scaler Reference InformationPart Numbers Included partsSuggested part Included parts Part numberFirmware Upgrade Installation Reference Information, cont’dU24 U60 U68U67 Installing labels in the scaler’s buttons Button LabelsFCC Class a Notice Extron’s Warranty Extron Electronics, USA
Related manuals
Manual 2 pages 53.37 Kb