Gefen EXT-HDMI-CAT5-844 user manual Scenario 2 B Example, Current source is 1A

Page 25

LED ARRAY DESCRIPTION

The LED array on the HDMI Over CAT5 Receiver is designed to inform the user of the currently selected source. Each receiver unit has a 4 LED array that will indicate which source is currently selected. Each input on the 8x4 CAT-5 Matrix for HDMI can accept two sources, therefore the LED array will act differently according to which input, “A” or “B”, is currently active.

•An input’s “A” source will be indicated by an single LED (the selected “A” input) that is ON.

•An input’s “B” source will be indicated by the reverse; a single LED will be OFF (the selected “B” input) while the remaining 3 LEDs will be ON.

The examples below will show some scenarios to illustrate the LED array functionality. Please note that it is not possible to have both “A” and “B” inputs active at the same time for any given input.

= LED ON

= LED OFF

Scenario 1 (”A” Example)

In 1

In 2

In 3

In 4

Current source is 1A

Scenario 2 (”B” Example)

In 1

In 2

In 3

In 4

Current source is 1A

22

Image 25

Contents 8x4 CAT-5 Matrix for Technical Support Asking for AssistanceTechnical Support Hours Write ToContents Gefen IntroductionGefen 8x4 CAT-5 Matrix for Hdmi How It WorksOperation Notes Package Includes FeaturesFront Panel Back Panel Sender Panel LayoutSender Panel Descriptions 13 24V DC Power Input How to Connect the 8x4 CAT-5 Matrix for Hdmi Connecting and Operating the 8X4 CAT-5 Matrix for HdmiHow to Operate the 8x4 CAT-5 Matrix for Hdmi Connecting the 8X4 CAT-5 Matrix for Hdmi Jumpers LED Indicator Input Selection Buttons RMT-16IR* Remote Control DescriptionWhy would I need to change the remote channel? RMT-16IR Remote Channel ConfigurationAm experiencing the issues listed above. What do I do? How Do I change the Remote Channel?EDID. What is it and what is it used for? Edid Management FeatureEdid Modes Edid Management OptionsFunction LED Array Description Scenario 1 a ExampleWhat are the communication port settings? How do I use these features?8X4 CAT-5 Matrix for Hdmi RS-232 Serial Communication Switching/Routing Binary Table 8X4 CAT-5 Matrix for Hdmi RS-232 CommandsEdid Management Modes Print Matrix Routing StateFront Panel Back Panel Top Panel Receiver Panel LayoutReceiver Panel Descriptions IR Blaster Functionality Operating the Hdmi Over CAT-5 ReceiverRMT-4IR Remote Control Description Auto Equalization & Boost Setting Hdmi Over CAT-5 Receiver Advanced ConfigurationIR Remote Channel Conﬁguration Equalization SettingCurrent source is 1A Scenario 2 B ExampleHdmi Over CAT-5 Receiver RS-232 Serial Communications Boost Settings Hdmi Over CAT-5 Receiver RS-232 CommandsSpecifications