Gefen EXT-HDMI-CAT5-844 user manual Scenario 1 a Example, LED Array Description

Page 16

LED ARRAY DESCRIPTION

The LED array on the 8x4 CAT-5 Matrix for HDMI is designed to inform the user of the current source to output routes. Each output has a 4 LED array that will indicate which source is currently selected. Each input can accept two sources and therefore the LED array will act differently according to which input, “A” or “B”, is active for each.

•An input’s “A” source will be indicated by an single LED (the selected “A” input) that is ON.

•An input’s “B” source will be indicated by the reverse; a single LED will be OFF (the selected “B” input) while the remaining 3 LEDs will be ON.

The examples below will show some scenarios to illustrate the LED array functionality. Please note that it is not possible to have both “A” and “B” inputs active at the same time for any given input.

= LED ON

= LED OFF

 

 

 

 

Scenario 1 (”A” Example)

 

Output-1

 

Output-2

Output-3

Output-4

Output 1 is selected to 1A

Output 2 is selected to 2A

Output 3 is selected to 3A

Output 4 is selected to 4A

 

 

Scenario 2 (”B” Example)

 

Output-1

 

Output-2

Output-3

Output-4

Output 1 is selected to 1B

Output 2 is selected to 2B

Output 3 is selected to 3B

Output 4 is selected to 4B

 

 

Scenario 3 (Mixed Example)

 

Output-1

 

Output-2

Output-3

Output-4

Output 1 is selected to 3A

Output 2 is selected to 4B

Output 3 is selected to 2A

Output 4 is selected to 1A

13

Page 15 Page 17
Image 16
Page 15 Page 17
Contents 8x4 CAT-5 Matrix for Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 8x4 CAT-5 Matrix for Hdmi How It WorksOperation Notes Features Package IncludesSender Panel Layout Front Panel Back PanelSender Panel Descriptions 13 24V DC Power Input How to Connect the 8x4 CAT-5 Matrix for Hdmi Connecting and Operating the 8X4 CAT-5 Matrix for HdmiHow to Operate the 8x4 CAT-5 Matrix for Hdmi Connecting the 8X4 CAT-5 Matrix for Hdmi Jumpers RMT-16IR* Remote Control Description LED Indicator Input Selection ButtonsRMT-16IR Remote Channel Configuration Why would I need to change the remote channel?Am experiencing the issues listed above. What do I do? How Do I change the Remote Channel?Edid Management Feature EDID. What is it and what is it used for?Edid Modes Edid Management OptionsFunction Scenario 1 a Example LED Array DescriptionWhat are the communication port settings? How do I use these features?8X4 CAT-5 Matrix for Hdmi RS-232 Serial Communication 8X4 CAT-5 Matrix for Hdmi RS-232 Commands Switching/Routing Binary TableEdid Management Modes Print Matrix Routing StateReceiver Panel Layout Front Panel Back Panel Top PanelReceiver Panel Descriptions Operating the Hdmi Over CAT-5 Receiver IR Blaster FunctionalityRMT-4IR Remote Control Description Hdmi Over CAT-5 Receiver Advanced Configuration Auto Equalization & Boost SettingEqualization Setting IR Remote Channel ConfigurationScenario 2 B Example Current source is 1AHdmi Over CAT-5 Receiver RS-232 Serial Communications Hdmi Over CAT-5 Receiver RS-232 Commands Boost SettingsSpecifications
Top Page Image Contents