Vidikron Vision 30 manual Connector Panel, Built-In Control Panel

Page 14

Controls and Functions

Connector Panel

To access the connector panel, press the door release button so it pops out. Turn the knob clockwise or counter-clockwise and pull firmly on it to open the door.

1.S-Video (mini DIN 4-pin) Y/C (S-video) signal input

2.12v Trigger (mini jack, diameter 5.5 mm outside, 2.5 mm inside) +12V output, active when the projector is turned on

3.Video (RCA Jack) Composite video signal input

4.Component (RCA Jacks)

480i Component (Y/CB/CR) video signal input

5.HDMI (High-Definition Multimedia Interface) Input Digital video signal input

6.RGB/ HDTV (BNC) or Progressive Scan DVD players DTV Y/PB/PR or DTV RGB video signal input

7.RS-232C (RJ-11 Jack)

RS-232C control signal input (refer to page 51 for details)

Built-In Control Panel

To control the projector when signals from a remote control

 

cannot reach it, use the built-in keypad next to the connector

 

panel.

 

Because the built-in keypad has fewer keys than the remote

 

keypad, certain projector functions are accessible only through

 

the menu system rather than via a direct key.

 

MEMORY

 

 

MEMORY

 

 

AUTO

 

 

AUTO

 

POWER

MENU

SOURCE

/EXIT

/ENTER

POWER

/EXIT

/ENTER

 

MENU

SOURCE

14

Vidikron Vision Model 30 Owner’s Operating Manual

Image 14
Contents DLP Projector Page Table of Contents Lamp Replacement Troubleshooting RS-232 Setup TWO Year Limited Warranty WarrantyRIGHTS, Limits and Exclusions Vidikron Safety Precautions Overview Intake Vent Front IR Sensor Vidikron Logo Exhaust VentTop IR Sensor Status LEDs Projection LensFront / Rear Adjusters Connector PanelAC Power in Socket AC Power Switch Cable Access Door Built-in Control PanelThis page is intentionally left blank Controls and Functions Control PanelConnector Panel Built-In Control PanelVidikron Logo Remote Control EnterRemote Control Control Panel Remote Control Functions Compared This page is intentionally left blank About the Batteries InstallationAbout the Remote Control Installation Considerations Screen Type and Size Front Screen InstallationsRear screen installations Screen sizeInstallation Ceiling Installation Floor InstallationMounting Folded Optics Connecting Video Inputs ConnectionsConnections Connecting an Hdmi Device Hdmi Source DVD player or HD tuner with Hdmi or DVI outConnecting to AC Power Adjusting Projector Height or Projection Angle Removing the Lens Cap Turning on the PowerAdjusting the Zoom and Focus Basic OperationRatio Selecting VideoMemory Selecting an Aspect Exitmenu Offon Turning off the Power On-Screen Display Menus Picture Quality Adjustments Color Temperature Standard 4/3 Image OptionsAnamorphic Letterbox IntelliWideCinema Cinema FillHD/RGB Adjust Projector Status Installation InstallationService ServiceEnter On-Screen Display Menus RS-232 Baud Rate ISF Calibration ISF CalibrationISF Enable Lamp Replacement Lamp Replacement Troubleshooting Troubleshooting RS-232 Pin Assignments Sub 9-pin female Pin RJ-11 Function RS-232 SetupConnecting RS-232 to the Projector RS-232C Control Codes Code FunctionRS-232C Control CodesThis page is intentionally left blank Specifications Horizontal Vertical Offset Lamp Lamp Life Inputs 12V OutputBrightness Contrast Power Requirements DimensionsDimensions RUMA-011140