Vidikron Vision 30 manual Projector Status

On-Screen Display Menus

Vision Model 30

Picture Adjust

Image Option

Projector Status

Installation

Service

ISF Calibration

Projector Status

Projector Status

Default	Load
Sleep Timer	30 Minutes
Lamp Power	200 W
Lamp Hours	+8 Hours
	0 Minutes

To load default settings, configure the sleep timer or adjust the lamp, press MENU, then press the ▲ or ▼ arrows to highlight Projector Status and press ENTER. The Projector Status sub-menu will then appear (see above). Press EXIT to return to the previous menu or press MENU to close all menus.

To restore the default image settings for the current input source ONLY, press the ▲ or ▼ arrow buttons to highlight “Load,” then press ENTER.

The Sleep Timer automatically puts the projector into standby mode after the amount of time you specify here. (A warning appears on-screen one minute before this is to occur.)

Press the ◄ or ► arrows to set the timer for anywhere from 10 minutes to 3 hours, in 10- minute increments. To disable the Sleep Timer, set it to 0.

Select Lamp Power from the Set Up Menu to adjust the lamp output level. You can choose to run the lamp as bright as possible (250W; this is the default setting) or you can choose the lower (200W) setting. Generally, lower lamp output can prolong the life of the lamp, but decreases brightness.







Default

Sleep Timer

Lamp Power

Lamp Hours indicates how long the currently-installed lamp has been in service. (This part of the menu is read-only.)



Lamp Hours

Vidikron Vision Model 30 Owner’s Operating Manual 39