Vidikron Vision 30 manual Turning off the Power

Page 32

Basic Operation

 

• Press OFF to turn off the projector.

Turning off the Power

• The POWER LED will blink green and the

 

 

fans will speed up for a quick cool-down. The

 

projector will not respond to any command

 

for 90 seconds.

 

• The POWER LED will light solid orange once

 

the cooling down cycle has completed.

OFF

 

ON

COMP 1

S-VID

VIDEO

The fans will run for three minutes to cool.

You can turn the projector back on after approximately two minutes.

32

Vidikron Vision Model 30 Owner’s Operating Manual

Image 32
Contents DLP Projector Page Table of Contents Lamp Replacement Troubleshooting RS-232 Setup TWO Year Limited Warranty WarrantyRIGHTS, Limits and Exclusions Vidikron Safety Precautions Overview Exhaust Vent Top IR Sensor Status LEDsIntake Vent Front IR Sensor Vidikron Logo Projection LensConnector Panel AC Power in Socket AC Power Switch Cable Access DoorFront / Rear Adjusters Built-in Control PanelThis page is intentionally left blank Controls and Functions Control PanelConnector Panel Built-In Control PanelVidikron Logo Remote Control EnterRemote Control Control Panel Remote Control Functions Compared This page is intentionally left blank About the Batteries InstallationAbout the Remote Control Installation Considerations Screen Type and Size Front Screen InstallationsRear screen installations Screen sizeInstallation Ceiling Installation Floor InstallationMounting Folded Optics Connecting Video Inputs ConnectionsConnections Connecting an Hdmi Device Hdmi Source DVD player or HD tuner with Hdmi or DVI outConnecting to AC Power Removing the Lens Cap Turning on the Power Adjusting the Zoom and FocusAdjusting Projector Height or Projection Angle Basic OperationRatio Selecting VideoMemory Selecting an Aspect Exitmenu Offon Turning off the Power On-Screen Display Menus Picture Quality Adjustments Color Temperature Image Options Anamorphic LetterboxStandard 4/3 IntelliWideCinema Cinema FillHD/RGB Adjust Projector Status Installation InstallationService ServiceEnter On-Screen Display Menus RS-232 Baud Rate ISF Calibration ISF CalibrationISF Enable Lamp Replacement Lamp Replacement Troubleshooting Troubleshooting RS-232 Pin Assignments Sub 9-pin female Pin RJ-11 Function RS-232 SetupConnecting RS-232 to the Projector RS-232C Control Codes Code FunctionRS-232C Control CodesThis page is intentionally left blank Specifications Horizontal Vertical Offset Lamp Lamp Life Inputs 12V OutputBrightness Contrast Power Requirements DimensionsDimensions RUMA-011140