Vidikron Vision 30 manual Installation

Page 22

Installation

Ambient Light In general, minimize or eliminate light sources directed at the screen. Contrast ratio in your images will be noticeably reduced if light directly strikes the screen, such as when a shaft of light from a window or floodlight falls on the image. Images may then appear washed out and less vibrant.

Other ConsiderationsOther considerations and tips that can help improve your installation:

Keep the ambient temperature constant and below 35°C (95°F). Keep the projector away from heating and/or air conditioning vents. Changes in temperature may cause drifts in the projector circuitry, which may affect performance.

Keep the projector away from devices that radiate electromagnetic energy such as motors and transformers. Common sources of these include slide projectors, speakers, power amplifiers and elevators.

Throw DistanceThrow distance is the distance measured from your projector’s lens to the screen. This is an important calculation in any projector installation as it determines whether or not you have enough room to install your projector with a desired screen size and if your image will be of the right size for your screen.

You can quickly estimate the throw distance by taking the width of the screen and multiplying it by the lens throw ratio that is applicable to your projector:

The Model 30 has a minimum throw distance factor of 1.38 and a maximum throw distance factor of 1.80.

The Model 30ET has a minimum throw distance factor of 1.88 and a maximum throw distance factor of 2.45.

�������������������������

������������������������������������������������������������

����������������

��

The result of this calculation tells you roughly how far back the projector should be positioned from the screen in order to project a focused image large enough to fill the screen.

For example, with an 8-foot (96-inch) wide screen (the maximum recommended screen width for this projector):

• The Model 30 has a throw distance range of between 132.48 inches (3.36 meters) and 172.80 inches (4.39 meters).

• The Model 30ET has a throw distance range of between 180.48 inches (4.58 meters) and 235.20 inches (5.97 meters).

22

Vidikron Vision Model 30 Owner’s Operating Manual

Image 22
Contents DLP Projector Page Table of Contents Lamp Replacement Troubleshooting RS-232 Setup TWO Year Limited Warranty WarrantyRIGHTS, Limits and Exclusions Vidikron Safety Precautions Overview Intake Vent Front IR Sensor Vidikron Logo Exhaust VentTop IR Sensor Status LEDs Projection LensFront / Rear Adjusters Connector PanelAC Power in Socket AC Power Switch Cable Access Door Built-in Control PanelThis page is intentionally left blank Controls and Functions Control PanelConnector Panel Built-In Control PanelVidikron Logo Remote Control EnterRemote Control Control Panel Remote Control Functions Compared This page is intentionally left blank About the Remote Control InstallationAbout the Batteries Installation Considerations Screen Type and Size Front Screen InstallationsRear screen installations Screen sizeInstallation Ceiling Installation Floor InstallationMounting Folded Optics Connecting Video Inputs ConnectionsConnections Connecting an Hdmi Device Hdmi Source DVD player or HD tuner with Hdmi or DVI outConnecting to AC Power Adjusting Projector Height or Projection Angle Removing the Lens Cap Turning on the PowerAdjusting the Zoom and Focus Basic OperationMemory Selecting an Aspect Selecting VideoRatio Exitmenu Offon Turning off the Power On-Screen Display Menus Picture Quality Adjustments Color Temperature Standard 4/3 Image OptionsAnamorphic Letterbox IntelliWideCinema Cinema FillHD/RGB Adjust Projector Status Installation InstallationService ServiceEnter On-Screen Display Menus RS-232 Baud Rate ISF Calibration ISF CalibrationISF Enable Lamp Replacement Lamp Replacement Troubleshooting Troubleshooting Connecting RS-232 to the Projector RS-232 SetupRS-232 Pin Assignments Sub 9-pin female Pin RJ-11 Function RS-232C Control Codes Code FunctionRS-232C Control CodesThis page is intentionally left blank Specifications Horizontal Vertical Offset Lamp Lamp Life Inputs 12V OutputBrightness Contrast Power Requirements DimensionsDimensions RUMA-011140