Vidikron operation manual Vision 120 Rear Panel

Controls and Functions

2.2

Vision 120 Rear Panel

Figure 2-2shows the Vision 120 rear panel.

15 14 13 12 11

.cover lamp the off pull to screw the Remove

Remove the screw to pull off the lamp cover.

SERVICE PORT

AUTHORIZED

PERSONNEL ONLY

L

L

1

2 3456 7 8 9 10

Figure 2-2. Vision 120 Rear Panel

1.LAMP COVER

Remove this cover to access the lamp compartment.

2.RUN LED

Lights blue to indicate that the projector is functioning normally.

3.LEFT BUTTON

Used to move the menu cursor left in the Vision 120 menu system.

4.UP BUTTON

Used to move the menu cursor up in the Vision 120 menu system.

5.DOWN BUTTON

Used to move the menu cursor down in the Vision 120 menu system.

6.RIGHT BUTTON

Used to move the menu cursor right in the Vision 120 menu system.

7.STAND-BY LED

Lights orange to indicate that the projector is in standby mode.

8. SOFT POWER BUTTON

Press once to turn on the Vision 120. Press it again to put the projector into Standby mode. For a discrete on or off command, you can use the direct access buttons on the remote control (see Figure 2-5).

9.PATTERN BUTTON

Press PATTERN to access the internal test pattern menu. Use arrow keys to select a pattern and press SELECT to confirm. Press PATTERN again to return to the selected source.

6 Vidikron Vision Model 120 Installation/Operation Manual