TANDBERG TC3.0 About monitors when you have a Codec C90, Main monitor, Dual monitors, # * # 0 2 #

TANDBERG Codec C90 and Profiles using C90 Administrator guide

ContentsContents

IntroductionIntroduction

AdvancedAdvancedconfigurationconfiguration

PassPasswordord protectionprotection

AboutAbAbout monitorsonitorsitors

AudioAudiomattersat ers

AppendicesAppendices

ContactContactusus

About monitors when you have a Codec C90

The main monitor

The main monitor can be connected to any of the video outputs HDMI 1 (the default connector for the main monitor) HDMI 3 (the default connector for the dual monitor), DVI-I 2 or DVI-I 4.

Connecting to HDMI 1

The HDMI 1 output is, by default, defined as the main monitor connector. When you connect the main monitor to this output the menu and icons (OSD - on screen display) will show on this monitor.

Connecting to DVI-I 2, DVI-I 4, HDMI 3

When connecting the main monitor to the DVI–I 2, DVI–I 4 or HDMI 3 output, you must move the OSD to this output.

If you cannot see any menu on screen you must run a key sequence on the remote control. The menu on screen, icons and other information (OSD - on screen display) will be moved to the selected output. At the same time, the resolution will be set to the default value, which is 1024x768@60Hz for DVI and 1280x720@60Hz for HDMI.

The video outputs at Codec C90

DVI-I 4

HDMI 3

(the default connector for the dual monitor)

DVI-I 2

HDMI 1

(the default connector for the main monitor)

Dual monitors

When you want to run a dual monitor setup, connect the second monitor to video output HDMI 3 on the codec.

Moving the OSD using the remote control

If the main monitor is connected to DVI-I 2 video output you must run the following shortcut or key sequence on the remote control.

•Disconnect * # * # 0 x # x=1 (HDMI 1); x=2 (DVI–I 2); x=3 (HDMI 3); x=4 (DVI–I 4)

Example: Set DVI-I 2 as the OSD output.

– * – # – * – # – 0 – 2 – #

Moving the OSD using API commands

You can also set the resolution and the OSD output by setting up a serial port connection and running API commands. See the API Guide for the codec for information about API commands.

Dual monitor configuration

Go to Advanced settings to set the monitor to dual:

1.Navigate to Settings > Advanced > Advanced settings > Video > Output > Monitor and set the Monitor to Dual.

D14635.02—MARCH 2010 40 www.tandberg.com