Runco CX-47HD, CX-OPAL47, CX-65HD operation manual Changing the PIP, Position

Operation

Press the PIP SRC button to select a PIP signal source. For each source, Table 4-2shows which of the other sources are available as a PIP source.

Table 4-2. Available Main and PIP Source Combinations

					PIP Input Source
		VIDEO 1	VIDEO 2	COMP. 1/SCART	COMP. 2	RGB	HDMI 1	HDMI 2	HDMI 3	HDMI 4
	VIDEO 1	–	√	√	√	√	√	√	√	√
	VIDEO 2	√	–	√	√	√	√	√	√	√
Source	COMP. 1/SCART	√	√	–	√	√	√	√	√	√
	COMP. 2	√	√	√	–	√	√	√	√	√
Input	RGB	√	√	√	√	–	√	√	√	√
	HDMI 1	√	√	√	√	√	–	–	–	–
Main
	HDMI 2	√	√	√	√	√	–	–	–	–
	HDMI 3	√	√	√	√	√	–	–	–	–
	HDMI 4	√	√	√	√	√	–	–	–	–

Notes:

1. “√” means that that source is available as a PIP source when that input is selected; “–” means that it is not.

2. The Crystal Series LCD cannot display the same source in both the main and PIP windows, nor can it display two HDMI (digital) signals simultaneously.

3. Disabled sources (refer to Source Enable on page 37) are not available as PIP sources.

Changing the PIP	➤	To change the PIP window position, press
Position		the POSITION button on the remote
		control repeatedly until the window is in the
		desired position.

16:9	4:3	LETTER	V WIDE
PIP	POSITION	SIZE	SWAP
PIP SRC	AUDIO 1	AUDIO 2	AUDIO 3

3

4

2

1

42 CX-47HD/CX-OPAL47/CX-65HD Installation/Operation Manual