Runco CX-OPAL47, CX-65HD, CX-47HD operation manual Sde

Serial Communications

Table 6-1. Serial Commands (continued)

	Command				Description
[		SDE	000#	Set PIP aspect ratio
				0	= 4:3
				1	= 16:9
Example: [SDE0001 selects 16:9 aspect ratio PIP window
[		SDF	000#	Set PIP window position
				0	= Top/Left
				1	= Top/Right
				2	= Bottom/Left
				3	= Bottom/Right

Example: [SDF0001 positions PIP window in upper-right corner of display area

The following serial commands are meant to emulate buttons on the remote control. Each button has its own serial command, so effectively it is as if you were using the IR remote only you’ll be doing so via serial commands. These commands provide active OSD responses just like the IR remote.

Each command begins with [key followed by the four-digit number of the button. No carriage return is necessary. The response you receive from the unit if the command is valid will be a right-bracket (]) followed by the four-digit numeric code you sent. (For example, the ‘ON’ com- mand is [key0015; the response will be ]0015). All commands are in ASCII.

[

[

[

key	0002	OFF
	0015	ON
key	0004	Number 1
	0005	Number 2
	0006	Number 3
	0008	Number 4
	0009	Number 5
	0010	Number 6
	0012	Number 7
	0013	Number 8
	0014	Number 9
	0035	Number 100
	0017	Number 0
key	0102	HDMI 1
	0101	HDMI 2
	0093	HDMI 3
	0094	HDMI 4
	0028	Component 1/SCART

CX-47HD/CX-OPAL47/CX-65HD Installation/Operation Manual 49