Sanyo DP42545 Using the Remote Control, Precautions, Remote Control Keys, Analog Brief Banners

USING THE REMOTE CONTROL

PRECAUTIONS

To ensure safe operation, please observe the follow- ing precautions:

Use (2) AAA alkaline batteries, see page 8.

Replace both batteries at the same time. Do not use a new battery with a used battery.

REMOTE CONTROL KEYS

➀Input Key—Press to change the input signal source as follows: Analog RF ➡ Digital RF ➡ Video1 ➡ Component2 ➡ Component3 ➡ Analog RF.

➁Number Keys—Two keys must be pressed to select a channel. Example: Press 0 then 6 to select channel 6. For Analog cable channels above 100, press and hold the 1 key until C1– – appears.

➂Info Key—Press to display Digital Full Banner or Analog Brief Banner information (press the INFO key again to remove the display).

Digital Off-air Channel Full Banner—Contains a two- part Channel Number (Major and Minor). If available, the following is also included—Station ID, Program Title, Date / Time (if set), Signal Strength, Video Resolu- tion, V-Guide Program Rating, and Audio Reception.

Program	Virtual Channel		Station ID	Current
Title	Major	Minor		Time/Date

		V-Guide	Audio
Video Resolution	Signal Strength
		Program Rating	Reception

Digital Off-air Channel Full Banner

Risk of explosion, if battery is replaced by an incorrect type.

If batteries have leaked in the Remote Control Unit, carefully wipe the case clean and load new batteries.

Do not expose the Remote Control Unit to moisture, or heat.

Digital Cable Channel Full Banner—Contains a two- part Cable Channel Number (Major and Minor). If available the following is also included—Date / Time (if set), Signal Strength, Video Resolution, V-Guide Program Rating, and Audio Reception.

	Cable	Virtual Channel		Current
				Time/Date
Indicator		Major	Minor
	“DC”

Video Resolution				V-Guide			Audio
		Signal Strength
				Program Rating		Reception
	Digital Cable Channel Full Banner
05	Analog	C 39	Analog
NBC		FOX			Video 1		Video 1
	Antenna		Cable
10:26 pm		10:26 pm			10:26 pm		Input

Analog Brief Banners

➃Recall Key—Select the first channel you want to watch; then select another channel using the NUMBER keys. Press RECALL to easily switch between the channels.

NOTE: The RECALL key can not toggle between a Digital and Analog channel. See TUNER key description.

➄Menu key—Press this key to display the on-screen setup menu.

➅Tuner Key—Use this key to toggle from one tuning system to another, digital channels and analog channels.

NOTE: The TUNER key is inactive when an external input is selected (Video1, Compo 2, or Compo 3).

14