Sanyo DP42545 Digital A/V Connections, DVD Player, TV Back Component Jacks Remote Control

DIGITAL A/V CONNECTIONS

USE THE COMPONENT JACKS TO CONNECT A DVD PLAYER OR OTHER DIGITAL EQUIPMENT

Switch off TV and external equipment before connecting cables. (Cables are not supplied.) Follow these steps to easily connect your STB or DVD to this Plasma TV.

1 Connect a DVD Player’s (or other digital equipment’s) Component Video Out to the TV’s Component Video Input jacks.

2	Connect a DVD Player’s (or other digital equipment’s)
	Audio Out to theTV’s Component L/R Audio Input jacks.
	Press the POWER key to turn on the Plasma TV. Turn
3 on external equipment.
4	Press the INPUT key to select the Input source
	(Compo 2 or Compo 3).

NOTE: “No Signal” will appear on the screen for five seconds when no signal or an unacceptable video format signal is detected at the Compo 2 or Compo 3 inputs.

						DVD Player
						(or other Digital	1
			Y	PB	PR	Device, such as,
			COMPONENT VIDEO OUT
	VIDEO OUT SELECT					a Digital Satellite
	S
OPT.	S-VIDEO OUT COPONENT		R	L		Receiver, or
DIGITAL
OUT			AUDIO OUT		VIDEO OUT
						Digital Cable Box)
	AUDIO		VIDEO 1		COMPO 2 COMPO 3
	OUTPUT	S-VIDEO			Y	Y
						RESET
					Pb	Pb
				V	Pr	Pr SERVICE	2
	L			L	L	L
				(MONO)
				AUDIO
	R			R	R	R

TV Back Component Jacks

Remote Control

	INPUT
				POWER
4		2		3
	1
	4		5	6

3

What you will need

for connections:

Component Video Cable – 1

Audio Cable – 1

■Compo 2 and Compo 3 jacks are identical. Compatible equipment can be connected to either set of jacks, such as, a DVD player connected to Compo 3 and a Satellite Receiver connected to Compo 2.

■Press the INPUT key after connecting the cables to select the Component 2 or Component 3 input signal. There is NO need to tune to a blank channel.

CONNECTING DIGITAL AUDIO OUTPUT TO A MULTI-CHANNEL RECEIVER

Dolby® Digital Audio provides 5.1 channels of surround sound (five full-range channels [5] and one low-frequency effect channel [.1]). A fiber optics cable is used to carry the 5.1 surround sound (for low-noise signal transfer).

1 Using a Fiber Optics cable, connect the TV’s Digital Audio Output to the Digital Audio Input of a Multi- Channel Receiver. (Fiber optics cable is not supplied.)

2 Press the POWER key to turn on the TV, then turn on the external equipment.

NOTES: When making the connection, do not pinch or kink the fiber optics cable.

Red light visible at the Digital Audio Output does not necessarily indicate that Dolby 5.1 audio is available. Digital audio is made up of light pulses that the human eye cannot detect. Dolby 5.1 audio is available at the Digital Audio Output only when received as part of a Digital antenna signal.

Multi-Channel

Receiver

1

Optical

Digital Cable

Back View of

Plasma TV

DIGITAL DIGITAL

AUDIO ANTENNA IN

OUTPUT

11