Dish Network 121716, DishPVR 508 Regulatory Factors, Safety Instructions, Wireless Remote Control

Page 2

REGULATORY FACTORS

WIRELESS REMOTE CONTROL

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this device may void your authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the use is encouraged to try to correct the interference by one or more of the following measures:

Re-orient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experience radio/TV technician for help.

SAFETY INSTRUCTIONS

You must keep safety in mind while using this device. Keep these and any other instructions for future reference.

INSTALLATION

Observe Warnings: Carefully follow all warnings on the device and in the operating instructions.

Heat: DO NOT place the device near heat sources such as radiators, stoves, heat registers, or other appliances that produce heat.

CARE AND USE

Cleaning: DO NOT use liquid, abrasive, solvent, or aerosol cleaners. Use a damp cloth for cleaning.

When Not in Use: Remove the batteries if this device is to be left unattended or unused for a long period of time.

Refer servicing to qualified personnel when a solid object or liquid has fallen onto or into the device.

DO NOT attempt to service this device. Refer all servicing to qualified personnel. Opening covers other than the battery cover will void the warranty.

Image 2
Contents Page Installation Safety InstructionsWireless Remote Control Regulatory FactorsContents of this User Guide Remote Control Basics Remote Control BatteriesRemote Control Signals UHF and IR Install AN Attenuator Stray UHF signals can block signals from the remote controlRegular Modes Remote Control ModesLimited Mode Remote Control Setup SET UP the Remote ControlScan for Device Codes Check the Device Codes Change the Address Switch Between TV and Device Volume Control To set the remote to control the device’s volumeRemote Control Buttons Control the ReceiverFavorite Lists Program Guide, Browse Banner, or Themes list open View Button 121716 Press the Record button to start recording a program Control a TV or a Second TV Press either Power button to turn the TV on or off Use these buttons to change channels on the TV Control a VCR or a Second VCR or a DVD Player Use these buttons to change channels on the VCR Control a Cable TV BOX Use these buttons to change channels on the cable box Control a Tuner or Amplifier Press this button to turn on or off the sound Device Codes TV CodesJVC VCR Codes Cable TV BOX Codes DVD Player Codes Troubleshoot the Remote Control What’s What’s Wrong What You Can Do HappeningTo use. See Remote Control Setup Limited Warranty United States of AmericaAdvance Exchange Program Post Receipt Exchange ProgramAccessory Warranty If YOU Need HelpIndex Part Number