Dish Network DishPVR 501, DishPVR 508, 121716 manual Remote Control Basics, Remote Control Batteries

Page 4

REMOTE CONTROL BASICS

This remote control gives you easy access to all the features

of a DISH Network satellite TV receiver and lets you control PVR features of a DISH Network DishPVR satellite receiver. These PVR features let you record programming with full digital quality, without a VCR.

You can set up the remote to control the satellite TV receiver and up to three other devices. These devices can be a TV, a VCR or DVD player, and a third device.

REMOTE CONTROL BATTERIES

The remote control requires AAA batteries. When you replace old batteries, you should replace all of the batteries. Use batteries of the same kind, for example, alkaline or carbon zinc, and don’t mix batteries of different kinds. Alkaline batteries last longer.

1.Press down on the battery cover’s top latch and lift the cover off.

2.Take out all of the old batteries.

3.Put the new batteries in. Make sure you match the plus (“+”) ends with the plus markings on the battery case.

4.Fit the battery cover’s bottom tab back into the slot at the bottom of the battery case, and snap the cover back into place.

2

121716

Image 4
Contents Page Safety Instructions Wireless Remote ControlInstallation Regulatory FactorsContents of this User Guide Remote Control Basics Remote Control BatteriesRemote Control Signals UHF and IR Install AN Attenuator Stray UHF signals can block signals from the remote controlLimited Mode Remote Control ModesRegular Modes Remote Control Setup SET UP the Remote ControlScan for Device Codes Check the Device Codes Change the Address Switch Between TV and Device Volume Control To set the remote to control the device’s volumeRemote Control Buttons Control the ReceiverFavorite Lists Program Guide, Browse Banner, or Themes list open View Button 121716 Press the Record button to start recording a program Control a TV or a Second TV Press either Power button to turn the TV on or off Use these buttons to change channels on the TV Control a VCR or a Second VCR or a DVD Player Use these buttons to change channels on the VCR Control a Cable TV BOX Use these buttons to change channels on the cable box Control a Tuner or Amplifier Press this button to turn on or off the sound Device Codes TV CodesJVC VCR Codes Cable TV BOX Codes DVD Player Codes Troubleshoot the Remote Control What’s What’s Wrong What You Can Do HappeningTo use. See Remote Control Setup Limited Warranty United States of AmericaAdvance Exchange Program Post Receipt Exchange ProgramAccessory Warranty If YOU Need HelpIndex Part Number