Dish Network DishPVR 501, DishPVR 508, 121716 manual Remote Control Buttons, Control the Receiver

4.Press the 0 number button.

5.Press the POUND (#) button.

The TV mode button flashes three times.

6.Press the SAT mode button.

7.Press the plus (+) and minus (-) sides of the VOLUME button.

The TV’s volume changes and the TV mode button lights instead of the AUX mode button.

REMOTE CONTROL BUTTONS

CONTROL THE RECEIVER

SAT MODE BUTTON

Press this button to set the remote to SAT (“satellite”) mode to control the receiver. The SAT mode button’s back light stays lit for about two seconds to show you’ve set the remote to SAT mode. Make sure you keep the remote in SAT mode to use the buttons described here.

TV/VIDEO BUTTON

If you connect the receiver with its back panel TV ANTENNA/CABLE IN and TV SET OUT ports, use this button to switch the receiver between the satellite signal (connect it to the SATELLITE IN port) and another video signal like a cable or broadcast TV antenna input (connect it to the receiver’s TV ANTENNA/CABLE IN input).

Note: If you connect the receiver to other devices with the phono (RCA) jacks or the S-VIDEOoutput, you must use the TV menus to change the input from local broadcast TV to satellite TV.

121716 11