Runco CX-40HD, CX-46HD manual Connecting External, Speakers Optional

Installation

The Crystal Series LCD Display is equipped with stereo speakers, which are mounted			Connecting External
directly below the screen. If you prefer, you can connect the rear-panel speaker outputs to			Speakers (Optional)
external speakers.
Connect the	(positive) and	(negative) speaker wires to the rear-panel SPEAKER-R

and SPEAKER-L terminals; see Figure 3-8.Maintain the correct polarity. For more information, refer to the owner’s manual for your speakers.

Twist exposed wire strands together.

Push tab to the
open position, and
insert the wire.
Then, close tab firmly to
secure the wire in place.	Right Speaker	Left Speaker

Figure 3-8. External Speaker Connection

You can also remove the built-in speakers if they are not needed; this permits installation of the display in locations where space above and/or below it is very limited. See Figure 3-9.

Remove these screws to allow the speakers to be detached.

Figure 3-9. Removing the Built-in Speakers

Runco CX-40HD/CX-46HD Owner’s Operating Manual 21