Operation
Setup ➤
Setup
OSD Language
PC Mode Adjust
Caption
Parental Control
Letterbox Mode
Input Selection
Monitor Out
Overscan
Input Label
HDMI Audio
RGB Signal
Film Mode
Auto Backlight
OSD Timer
Auto Off
Use the controls in the Setup menu to perform advanced image quality adjustments and access various other Crystal Series LCD Display features.
OSD Language: Select OSD Language from the Setup menu and press ENTER. Then, use the up- or
PC Mode Adjust: To improve the quality of displayed images from a computer or other
ENTER.
•Auto Adjust: Auto Adjust automatically adjusts settings to optimize computer images. To execute Auto Adjust on command, select Auto Adjust and press ENTER.
Note | Auto Adjust may take some time to complete, depending on the |
characteristics of the incoming signal. |
•Clock: Use the up- or 
, 
) to highlight Clock. Then, use the 
) to increase the pixel clock rate; use the 
) to decrease it.
•Phase: Adjust the phase if the image shows shimmer or “horizontal” noise. Pixel phase adjusts the phase of the pixel sampling clock relative to the incoming signal. The effect of this control is similar to that of a tracking control on a VCR.
For best results, use a good test pattern such as a smooth gray consisting of a clear pattern of black and white pixels, or a similar “half on, half off” graphic image. (You may notice that you can stabilize the image at more than one point. Use either setting in this case.)
•H Position: Use the up- or 
, 
) to highlight H Position. Then, use the 
) to shift the image to the right; use the 
) to shift the image to the left.
•V Position: Use the up- or 
, 
) to highlight V Position. Then, use the 
) to shift the image up; use the 
) to shift the image down.
To restore the
Caption: Select Caption from the Setup menu to control the display of closed captions when watching programs that contain them.
•Display: Select On or Off to control the display of closed captions.
•Digital Mode: For digital TV broadcasts, select one of six captioning modes (Service1, Service2 ... Service6). Service1 usually contains the
•Analog Mode: Select one of four captioning modes: CC1, CC2, CC3 or CC4. CC1 usually contains the
The Crystal Series LCD Display also supports “text mode” captioning; to use this feature, select Text1, Text2, Text3 or Text4. The text modes, instead of displaying a few lines of captions somewhere on the picture, take over all or half of the screen to display scrolling text information. (The text modes are seldom used today, so most of the time there is no information there to see.) The text field is sometimes used for
38 | Runco |