Runco CX-40HD, CX-46HD manual Operation, Turning on the Power, Changing the OSD Language

4. Operation

1.Turn on your source components.

2.Plug the female end of the supplied power cord into the AC receptacle on the rear of the Crystal Series LCD Display (AC 100V ~ 240V). See Figure 2-2.

3.Connect the other end to your AC power source.

4.Turn on the main power switch at the rear of the display. The power indicator lights red to indicate that the Crystal Series LCD Display is in “standby” mode.

5.Press the ON button on the remote control to turn on the display (or press the power button on the side of the display). The power indicator

flashes for a few seconds, then lights solid	OFF		ON
green.
6. After a brief warm-up period (approximately 10	1	2	3
seconds), the Crystal Series LCD Display will
display an image.	4	5	6
	7	8	9

4.1

Turning on the Power

The Crystal Series LCD Display OSD language is initially set to English, but can also display the menus in French, Spanish, Portuguese or German. To change the OSD language:

1.Press MENU.

2.Select Setup from the Main Menu.

3.Select OSD Language from the Setup Menu.

4.Press or to highlight the desired language and press ENTER. The change takes effect immediately.

4.2

Changing the OSD Language

Runco CX-40HD/CX-46HD Owner’s Operating Manual 25