HP C4599 Solution 2 Refresh the Windows Device Manager, To refresh the Windows Device Manager

Models: C4580 C4599

1 261
Download 261 pages 11.49 Kb
Page 171
Image 171

Troubleshooting

Chapter 13

Solution 2: Refresh the Windows Device Manager

Solution: Refresh the Windows Device Manager.

To refresh the Windows Device Manager

1.On the Windows taskbar, click Start, right-click My Computer, and then click Properties.

2.Click the Hardware tab, and then click Device Manager.

3.Double-clickUniversal Serial Bus Controllers.

4.Click USB Composite Device, click Action, and then click Uninstall. If a screen appears to confirm the deletion, confirm the deletion.

5.Disconnect the USB cable from the product.

6.Wait a few seconds, and then reconnect the cable.

This should restart the Windows device detection (Plug and Play). A New Hardware found screen might appear.

7.Click Next through all of the screens that appear in the Wizard to install the USB Composite Device.

8.Click Finish to complete the installation.

9.Try to scan again.

10.If these steps do not resolve the problem, try using a different USB cable to connect the product to the computer.

Cause: Communication problems between the product and the USB controller caused this error to occur. This might be caused by an incomplete installation, a USB cable longer than 3 meters (9.8 feet) in length, or a defective USB cable.

If this did not solve the issue, try the next solution.

Solution 3: Verify if the Digital Imaging Monitor is running

Solution: Verify that the Digital Imaging Monitor is running.

To check that the Digital Imaging Monitor is running

1.Look for the Digital Imaging Monitor icon in the system tray at the lower right side of the screen, near the time.

2.If the Digital Imaging Monitor icon is not present, restart the computer.

3.After the computer restarts, try to scan again.

Cause: The Digital Imaging Monitor was not running.

If this did not solve the issue, try the next solution.

168 Troubleshooting

Page 171
Image 171
HP C4599, C4580 manual Solution 2 Refresh the Windows Device Manager, To refresh the Windows Device Manager