Chapter 4

Connection information

To print the wireless test report

1.Press the Wireless button on the product.

2.Press the button next to the down arrow on the display until Wireless Network Test is highlighted, and then press OK.

The Wireless Network Test prints.

Related topics

Network troubleshooting” on page 109

Network configuration page definitions

The network configuration page shows the network settings for the HP All-in-One. There are settings for general information and 802.11 wireless.

This section contains the following topics:

General network settings

Wireless (802.11) network settings

Related topics

Print network settings” on page 19

Network glossary” on page 24

General network settings

The following table describes the general network settings shown on the network configuration page.

Parameter

Network Status

Active connection type

URL

Firmware

Revision

Hostname

Description

Status of the HP All-in-One:

Ready: The HP All-in-One is ready to receive or transmit data.

Offline: The HP All-in-One is not currently connected to the network.

Network mode of the HP All-in-One:

Wireless: The HP All-in-One is connected to a wireless (802.11) network.

None: There is no network connection.

The IP address of the Embedded Web Server.

NOTE: You will need to know this URL when you try to access the Embedded Web Server.

The internal networking component and device firmware revision code.

NOTE: If you call HP Support, depending on the problem, you might be asked to provide the firmware revision code.

The TCP/IP name assigned by the installation software to the device. By default, this is the letters HP followed by the last 6 digits of the Media Access Control (MAC) address.

20 Connection information

Page 23
Image 23
HP C4599, C4580 To print the wireless test report, Wireless Network Test prints Related topics, General network settings