HP C4580, C4599 manual Solution 11 Check the USB chipset and controller

Models: C4580 C4599

1 261
Download 261 pages 11.49 Kb
Page 178
Image 178

5.Go to the Utility section and download the HP Scan diagnostic utility.

6.Try to scan.

If an error condition is identified with any of the HP software components, a red X is displayed next to the component. If there is no error condition, a green check mark is displayed next to the component. The utility is equipped with a Fix button to correct the error conditions.

Cause: There was a problem with the connection between the product and the computer.

If this did not solve the issue, try the next solution.

Solution 10: Download and install the unexpected internal error and communications failure patch

Solution: Download and instal the unexpected internal error and communications failure patch.

This patch resolves the An unexpected internal error has occurred error and other communication failures with the product.

To install the patch

1.Go to: www.hp.com and click Software and driver downloads.

2.Select Download drivers and software (and firmware).

3.Select the operating system of your computer where the HP software is installed.

4.Go to the Patch section and download the HP Image zone/photo and imaging unexpected internal error and communications failure patch.

5.Double-click the patch to install it on the computer.

6.Try to scan.

Cause: You needed to install the unexpected internal error and communications failure patch.

If this did not solve the issue, try the next solution.

Solution 11: Check the USB chipset and controller

Solution: Check the USB chipset and controller.

Scan communication errors can occur because of compatibility issues with USB chipsets installed on the computer. This can be caused by a mismatch in the handshake timing between HP product chipset and certain types of USB chipsets on the computer.

Troubleshooting

To check the USB chipset and controller

1.On the Windows taskbar, click Start, right-click My Computer, and then click Properties.

2.Click the Hardware tab, and then click Device Manager.

3.Open Universal Serial Bus Controllers by clicking the plus sign (+) next to it.

Errors 175

Page 178
Image 178
HP C4580, C4599 manual Solution 11 Check the USB chipset and controller, To check the USB chipset and controller