Winegard RD-4610 owner manual Installation & Assembly

Page 2

INSTALLATION & ASSEMBLY

STEP 1. Choose a location for antenna that will allow it to rest in travel position with antenna pointing toward rear of vehicle and raise and rotate without interfering with other roof-mounted equipment. Make sure inside ceiling area is clear where ceiling plate will mount.

NOTE: Figure 1 shows minimum distance (10") antenna should be located from edge of vehicle roof. We recommend you check with your dealer or the manufacturer to see what provisions have been made in the roof for antenna mounting. A reinforced area of roof as well as pre-wire downlead may be available.

NOTE: The system must be level for proper operation. If you have a curved roof you should use a Winegard Model RW-1000 wedge kit to level the system.

STEP 2. Position template on roof (last page of manual) and drill a 1-1/2" hole through roof and ceiling of vehicle. Take care to avoid damage to wiring which may run between roof and ceiling.

It is highly recomended that the antenna be mounted on roof center line. Do not mount antenna closer than 10" from edge of roof.

RW-1000

Roof Wedge

Vehicle Roof

Interior Roof

Antenna ControlsWedge,

Optional

NOT TO SCALE

Rev. 2/2001

2

FIGURE 1

Image 2
Contents Install Point Base Toward Front Vehicle WinegardInstallation & Assembly Antenna Shown Partially Raised For Ease of Illustration only Except for screw indicated in Figure Inside RV Travel Position Approximately Degrees from Travel PositionDirectional Handle Point to Front of RVOperation ElevationLowering Antenna to Travel Position Tuning Antenna for Best PictureWatching OFF-AIR TV Position Except Travel Position DO’SVCR Mount Lubrication MaintenanceElevating Shaft & Worm Gear Assembly Replacement Procedure Lubricating Rubber Quad RingOrdering Repair Parts Trouble Shooting No PictureWarranty Repair Work Antenna does not or is Hard to RotateParts List Rear ViewNot to Scale Parts List Interior Hardware KIT RK-CEIL Crank Handle KIT RK-HANDSpecifications Model RP-4200 Thick Roof KIT AvailableRev