Winegard RD-4610 owner manual Operation, Elevation

Page 7

OPERATION

STEP 1. Using a compass, determine which direction is North. It is recommended that you step outside to perform this step. Standing in or near coach/RV can give you an incorrect reading. The more accurately you determine North, the easier it will be to find the satellite(s).

Directional Handle

Elevating Crank

Directional Handle

Directional Dial

Pointer

 

FIGURE 5

Rotation Clamp

STEP 2. Move rotation clamp to the LOCK position.

STEP 3. Rotate directional dial (see Figure 5) until the arrow is pointing North.

STEP 4. Unsnap elevation crank and turn (clockwise) in direction of "UP" arrow, about 14 - 15 turns or until some resistance is met.

STEP 5. Turn receiver ON, and access installation menus to determine antenna elevation and direction/heading. See receiver owner manual for menu access instructions.

STEP 6. Move rotation clamp to the ROTATE position. Turn directional handle until pointer on directional handle is pointing in direction indicated by the receiver. Example: If receiver says point antenna at 145° then rotate directional handle so that pointer is pointing at 145o on the directional dial.

ELEVATION

TURNS CCW

14 - 16o

NONE

17 - 19o

1/2

20 - 22o

1

23 - 26

1-1/2

27 - 29o

2

30 - 32o

2-1/2

33 - 36o

3

37 - 39o

3-1/2

40 - 43o

4

44 - 46o

4-1/2

47 - 50o

5

51 - 53o

5-1/2

54 - 57o

6

58 - 60o

6-1/2

61 - 64o

7

65 - 67o

7-1/2

 

 

STEP 7. Refer to table below and turn elevation crank counter clockwise (CCW) the number of turns indicated to get the elevation shown by the receiver. One full turn equals approximately 7° of elevation change.

Rev 7/97

7

Image 7
Contents Winegard Install Point Base Toward Front VehicleInstallation & Assembly Antenna Shown Partially Raised For Ease of Illustration only Except for screw indicated in Figure Inside RV Point to Front of RV Approximately Degrees from Travel PositionDirectional Handle Travel PositionElevation OperationPosition Except Travel Position DO’S Tuning Antenna for Best PictureWatching OFF-AIR TV Lowering Antenna to Travel PositionVCR Lubricating Rubber Quad Ring MaintenanceElevating Shaft & Worm Gear Assembly Replacement Procedure Mount LubricationAntenna does not or is Hard to Rotate Trouble Shooting No PictureWarranty Repair Work Ordering Repair PartsRear View Parts ListNot to Scale Crank Handle KIT RK-HAND Parts List Interior Hardware KIT RK-CEILModel RP-4200 Thick Roof KIT Available SpecificationsRev