Winegard RD-4610 owner manual Inside RV

Page 5

CAUTION: DO NOT GET SEALING COMPOUND ON BEARING SURFACE BETWEEN BASE PLATE AND ROTATING GEAR HOUSING. DO NOT PAINT TOP OF BASE PLATE OR AROUND ROTATING GEAR HOUSING.

NOTE: Apply sealant approved for your vehicle roof between Base Plate and roof of vehicle.

Cable clamp on gear housing.

Cable Ties

FIGURE 3

#10 x 1" Screws

Make sure cable entry is sealed

3" min.

Attach cable clamp here. Make sure there are 16" of coax between the cable clamp on the gear housing and the one here 3" in front of base plate. TOO MUCH OR TOO LITTLE WILL CAUSE DAMAGE TO COAX.

Apply approved sealant under lip and cable roof hole

STEP 11. Feed downleads through roof using Winegard Model CE-2000 cover plate (included with hardware). Weatherproof cable entry by applying approved sealant under lip of roof-thru plate and where cable enters roof. Attach plate to roof with screws provided. Apply approved sealant over screws and around edge of roof-thru plate, making sure cable entry is sealed. Secure cables as necessary to prevent whipping. Use tie-wraps provided to secure cables together.

STEP 12. Connect satellite coax downlead to satellite receiver, refer to receiver manual on proper connections. If coax connections are made outside the coach YOU MUST WEATHERPROOF THE CONNECTIONS!

INSIDE RV

STEP 13. Assemble ceiling plate, directional handle and crank handle as shown in Figure 4. The circled numbers indicate placement from the ceiling down. Example: The ceiling plate 1 is located next to the ceiling. The elevation crank handle 8 is farthest from the ceiling. The number also indicates sequence of assembly.

CAUTION: USE CAUTION WHEN INSTALLING THE ELEVATING CRANK. ONCE SCREW TOUCHES SHAFT, TIGHTEN ONLY 1/4 TURN MORE. SCREW SIMPLY HOLDS ELEVATING CRANK ON. DO NOT OVERTIGHTEN!

5

Image 5
Contents Winegard Install Point Base Toward Front VehicleInstallation & Assembly Antenna Shown Partially Raised For Ease of Illustration only Except for screw indicated in Figure Inside RV Directional Handle Approximately Degrees from Travel PositionTravel Position Point to Front of RVElevation OperationWatching OFF-AIR TV Tuning Antenna for Best PictureLowering Antenna to Travel Position Position Except Travel Position DO’SVCR Elevating Shaft & Worm Gear Assembly Replacement Procedure MaintenanceMount Lubrication Lubricating Rubber Quad RingWarranty Repair Work Trouble Shooting No PictureOrdering Repair Parts Antenna does not or is Hard to RotateRear View Parts ListNot to Scale Crank Handle KIT RK-HAND Parts List Interior Hardware KIT RK-CEILModel RP-4200 Thick Roof KIT Available SpecificationsRev