Winegard RD-4610 owner manual Approximately Degrees from Travel Position, Directional Handle

Page 6

CAUTION: After INITIAL

FIGURE 4

INSTALLATION,

 

the antenna SHOULD ROTATE

 

APPROXIMATELY 360

 

DEGREES FROM TRAVEL

 

POSITION.

 

The pointer on the

 

DIRECTIONAL HANDLE

 

should point towards the

 

ROTATION CLAMP when in

 

TRAVEL POSITION.

 

1 Ceiling Base

POINT TO

FRONT OF RV

POINTER MUST POINT TO CENTER OF ROTA- TION CLAMP WHEN IN TRAVEL POSITION

ASSEMBLED VIEW

3 Directional

Handle Extension

2 (4) #10 Phillips Flat

Head Screws

4 Directional

Handle

ALIGN POINTER

WITH ANTENNA

TRAVEL POSITION

5 ELEVATING CRANK HANDLE (When installed, extends 2-1/4" from ceiling). Snap Handle into base when not in use.

Rotation

Clamp

POINT TO

FRONT OF RV

Tighten screw snugly

6Rev 6/05/01

Image 6
Contents Install Point Base Toward Front Vehicle WinegardInstallation & Assembly Antenna Shown Partially Raised For Ease of Illustration only Except for screw indicated in Figure Inside RV Travel Position Approximately Degrees from Travel PositionDirectional Handle Point to Front of RVOperation ElevationLowering Antenna to Travel Position Tuning Antenna for Best PictureWatching OFF-AIR TV Position Except Travel Position DO’SVCR Mount Lubrication MaintenanceElevating Shaft & Worm Gear Assembly Replacement Procedure Lubricating Rubber Quad RingOrdering Repair Parts Trouble Shooting No PictureWarranty Repair Work Antenna does not or is Hard to RotateParts List Rear ViewNot to Scale Parts List Interior Hardware KIT RK-CEIL Crank Handle KIT RK-HANDSpecifications Model RP-4200 Thick Roof KIT AvailableRev