Winegard RD-4610 owner manual Antenna Shown Partially Raised For Ease of Illustration only

Page 3

STEP 3. Attach reflector to backup assembly as shown in Figure 2.

STEP 4. Attach RS-1000 antenna to elevating tubes, see Figure 2, using the two Eclips and pins provided. Attach coax cable to F-jack on antenna, slide weather boot over boot collar.

RS-1000 Antenna

Reflector

(4)5/16-18 x 5/8" Flat Head Bolt

(4) 5/16-18 Hex Nut

Backup Assembly

(4) 5/16" Flat Washer

NOTE: Make sure that coax cables fits between the reflector and the fixed feed arm.

ANTENNA SHOWN PARTIALLY RAISED

FOR EASE OF ILLUSTRATION ONLY

FIGURE 2

Attach coax cable to F-jack on antenna, slide weather boot over boot collar.

Attach RS-1000 to elevating tubes using E-clips and pins supplied.

Rev. 2/98

3

Image 3

Contents Winegard Install Point Base Toward Front VehicleInstallation & Assembly Antenna Shown Partially Raised For Ease of Illustration only Except for screw indicated in Figure Inside RV Point to Front of RV Approximately Degrees from Travel PositionDirectional Handle Travel PositionElevation OperationPosition Except Travel Position DO’S Tuning Antenna for Best PictureWatching OFF-AIR TV Lowering Antenna to Travel PositionVCR Lubricating Rubber Quad Ring MaintenanceElevating Shaft & Worm Gear Assembly Replacement Procedure Mount LubricationAntenna does not or is Hard to Rotate Trouble Shooting No PictureWarranty Repair Work Ordering Repair PartsRear View Parts ListNot to Scale Crank Handle KIT RK-HAND Parts List Interior Hardware KIT RK-CEILModel RP-4200 Thick Roof KIT Available SpecificationsRev