Memorex MVDP1072 manual Connecting to Power Supply, Installing Battery Pack

Page 14

PREFACE

Connecting to Power Supply

1Connect the AC cord with the power adapter. (See picture A )

2Connect the output plug of to this player's power adapter.

3Connect the power adapter to an AC power source.

AB

1Connect the car adapter to an DC power source in the car. (See picture B )

Installing Battery Pack

1Installing Battery Pack

Insert the clasps of the battery pack into the holes in the bottom of this player as shown in the figure.

Slide the battery pack to secure it.

Battery Pack

Portable DVD

Player

2Recharging Battery Pack

Indicator

Power Adapter

Insert the output plug of the power adapter into the battery pack's power socket. The battery pack indicator will be orange for 0.5 seconds, then the indicator will flash green, which shows the battery pack is being recharged.

When the battery pack is going to be fully recharged, the indicator will flash orange.

The indicator will be green when the battery is fully recharged.

.If the indicator lights up in red, the battery pack has problems and needs repair.

You can charge the battery while using the DVD player. You must have the power connected to the battery pack and not to the main unit.

The usage of car adapter is the same as using the standard home power adapter.

9

Image 14

Contents User’s Guide Important Safety Instructions Safety Instructions Contents Function Setup Preface Brief Introduction to DVDOn this Unit Features Audio/Video FeaturesCompatible Disc Types SvcdControl Button Locations and Explanations Control Button Locations and Explanations Remote Control Illustration MENU/PBC ButtonHow to use the Remote Control Battery InstallationConnecting to Power Supply Installing Battery PackConnecting to a TV set Connecting to an Ordinary Audio System System ConnectionsConnecting to an Amplifier with Dolby Digital Decoder Connecting to an Amplifier with DTS Digital Decoder Audio/Video In AUX Press OPEN/CLOSE to open the disc lid Connect the player to the power supplyPlease refer to page9Playback Close the disc lidPress PAUSE/STEP button in playback status TV System Selection NTSC/PALPause/Step Playback Press OSD button To restore playback, press the Play buttonOSD On Screen Display Press Volume button on the remote control of this unit KEY/Volume ControlPress Volume button on TV set or Amplifier to adjust volume DVD Menu PlaybackPBC PlayBack Control Functions Main menu displays on TV screenLanguage/Audio Channel Selection Press Audio buttonMute Resume audio outputPress FWD and the player starts fast forward playback Fast PlaybackSlow Playback Press REV and the player starts fast reverse playbackPress A-B for the third time Repeat PlaybackRepeat the Selected Section Press Subtitle to select the desired language Subtitle SelectionAngle Selection Press Angle and the TV screen displaysPlayback from a Desired Point Power Spectrum MeterPSM graphic equalizer Picture Quality Setting Virtual Keyboard To exit the virtual keyboard, press Function Select againTo exit the browser interface, press Browser again Press BROWSER, the screen displays as followsPress UP/DOWN arrows to select the desired item MP3 and Jpeg File Playing Plays a disc with both MP3 and Jpeg files Playing MP3 FilePlaying Jpeg File When the button is invalid, the TV screen displays Other Basic Operating MeansFunction Setup Press SETUP. The TV screen displaysGeneral Settings Press Setup to exit the setup menuSharpness Used to set the sharpness of video output Video SetupScreen saver Turn the screen saver function on or off Sound Field To set different sound field effects Audio SetupEQ type To set EQ modes TV Type To set the output video system of this player Initial SetupAudio To set the prefered audio language when playing PBC To set the PBC statusUseful notes Troubleshooting OthersSpecifications CD-DA MP3Terms 525/60DVD-R SIGNAL-TO-NOISE Ratio Language Code List Code Language NameOthers Page Memcorp, Inc Weston, FL