Memorex MVDP1072 manual Others, Troubleshooting

Page 44

OTHERS

Troubleshooting

Please check the following chart for solutions to your problem before contacting any service and support personnel.

Symptom		Cause	Correction
Symptom		Cause	Correction

		Signal not properly connected.	Connect signal securely.
No sound		Disc warped or dirty.	Clean your disc.
		Player in mute status.	Press MUTE button again.

		Signal not properly connected.	Connect signal securely.
No picture		Signal not properly connected.	Reset the AV/TV status of your
No picture		TV not set for proper system.	Reset the AV/TV status of your
		TV not set for proper system.	TV set.
			TV set.

		TV system not right.	Press P/N button on the remote
No color		TV system not right.	control to set the system.
No color		TV set color not properly adjusted.	Readjust color of your TV set.
		TV set color not properly adjusted.	Readjust color of your TV set.

		No disc in the player.	Load a disc.
		No disc in the player.	Reload a disc, with the label side
No disc reading			Reload a disc, with the label side
No disc reading		Disc not properly loaded.	facing up.
		Condensation on the laser head.	Turn on the player, unload the
		Condensation on the laser head.	disc and leave it on for about one hour.
			disc and leave it on for about one hour.

		Remote control not pointing to the	Use the remote control properly.
Remote control		sensor window.	Use the remote control properly.
Remote control		Remote control's operating distance
failure		more than 8 meters away from the sensor	Replace the battery.
		window of the player	Replace the battery.
		Batteries low.
			Wait for 5 to 10 seconds and this
		Mal-fabricated disc used.	player will restore normal functions.
Temporary		Wrong buttons pressed.	Press other buttons.
function failure		Foreign static electricity leaks	Press other buttons.
function failure		Foreign static electricity leaks
		inside the enclosure.	Restart this player after powering
			this player off for 1 to 2 minutes.

Picture rolling		TV set system not properly adjusted.	Readjust system of your TV set.

Too much in		The rechargeable battery becomes	Recharge the battery.
terference strip		The rechargeable battery becomes	Recharge the battery.
terference strip		low	Use the power adapter.
es on image		low	Use the power adapter.

39

Image 44

Contents User’s Guide Important Safety Instructions Safety Instructions Contents Function Setup Preface Brief Introduction to DVDOn this Unit Features Audio/Video FeaturesCompatible Disc Types SvcdControl Button Locations and Explanations Control Button Locations and Explanations Remote Control Illustration MENU/PBC ButtonHow to use the Remote Control Battery InstallationConnecting to Power Supply Installing Battery PackConnecting to a TV set Connecting to an Ordinary Audio System System ConnectionsConnecting to an Amplifier with Dolby Digital Decoder Connecting to an Amplifier with DTS Digital Decoder Audio/Video In AUX Connect the player to the power supplyPlease refer to page9 PlaybackPress OPEN/CLOSE to open the disc lid Close the disc lidPress PAUSE/STEP button in playback status TV System Selection NTSC/PALPause/Step Playback Press OSD button To restore playback, press the Play buttonOSD On Screen Display KEY/Volume Control Press Volume button on TV set or Amplifier to adjust volumePress Volume button on the remote control of this unit DVD Menu PlaybackPBC PlayBack Control Functions Main menu displays on TV screenLanguage/Audio Channel Selection Press Audio buttonMute Resume audio outputFast Playback Slow PlaybackPress FWD and the player starts fast forward playback Press REV and the player starts fast reverse playbackPress A-B for the third time Repeat PlaybackRepeat the Selected Section Subtitle Selection Angle SelectionPress Subtitle to select the desired language Press Angle and the TV screen displaysPlayback from a Desired Point Power Spectrum MeterPSM graphic equalizer Picture Quality Setting Virtual Keyboard To exit the virtual keyboard, press Function Select againTo exit the browser interface, press Browser again Press BROWSER, the screen displays as followsPress UP/DOWN arrows to select the desired item MP3 and Jpeg File Playing Plays a disc with both MP3 and Jpeg files Playing MP3 FilePlaying Jpeg File When the button is invalid, the TV screen displays Other Basic Operating MeansFunction Setup Press SETUP. The TV screen displaysGeneral Settings Press Setup to exit the setup menuSharpness Used to set the sharpness of video output Video SetupScreen saver Turn the screen saver function on or off Sound Field To set different sound field effects Audio SetupEQ type To set EQ modes Initial Setup Audio To set the prefered audio language when playingTV Type To set the output video system of this player PBC To set the PBC statusUseful notes Troubleshooting OthersSpecifications CD-DA MP3Terms 525/60DVD-R SIGNAL-TO-NOISE Ratio Language Code List Code Language NameOthers Page Memcorp, Inc Weston, FL